NAPCO PIR1710 Installation Manual

PIR1710 PASSIVE INFRARED S ENSOR
INSTALLATION INST RUCTIONS
SPECIFICATIONS Coverage (l x w):
70’ x 60’ (21.3m x 18.3m) at 20°C
(68°F), typical.
Operating Temperature: Mounting: Output: Relay T i me:
Wall or corner, 12’ (3.6m) max.
Normally-Closed Form-A Relay
Approximately 3 seconds
Contact Ratings
Alarm Relay:
100mA, 24Vdc with internal 10Ω current-
limiting resistor
Power-Supply Requirements
Note:
This unit is intended for operation from a power source that provides a 4 hour battery backup in the event of a power fai lure .
Filtered Dc:
10.6 to 16Vdc nominal with battery backup
from control panel .
Current Drain:
23mA (idle or alarm) at 12Vdc (nominal)
Physical
Dimensions:
3.3” x 2.5” x 1.9” (8.4cm x 6.4cm x 4.8cm)
(HxWxD)
Shipping Weight:
5oz (142gm)
FEATURES
Lookdown zone provides coverage directly beneath sensor
Selectable Fixed (2 Pulse Bipolar ) or Signal-Se le ctive Process-
TM
ing
(SSP) Detection for optimum immunity to false alarms
Unique circuit design protects against false alarms due to radio­frequency interference
Vertical and horizontal aiming capabilities
Dual-element sensor
Large lens area assures high sensitivity
Small size with ample wiring space
Power filtering provides protection against transients
Corner mountable
REPLACING THE LENS
The lens is mounted on a Lens Support insert that fits inside the front cover. To install one of the accessory lenses, proceed as follows.
1. While pushing the lens in at the top, wi th fi n­gers straddling the LED jewel, press down at the top of the Lens Support as shown until the sup­po rt clear s the t hree to p retainers. Be careful not to dislodge the look­down-lens window.
2. Push the Lens Support up until it clears the three bottom retain ers a n d remove the assembly.
3. Straighten the lens tabs and slide out the lens.
4. Install the replacement lens: slide the tabs into the slots in the L ens Support , the n bend the tabs in ward.
5. Ins t al l the as semb l y i n to the fro n t co ver (b e su r e l en s is right side up, as it will fit either way): slip the Lens S upport behin d the l owe r r e tainers, then pus h in at the top unti l th e Lens Support snaps into place .
MO UNTI NG & WI RING
Allow at least three minutes for the unit to settle. The LED will not function until the unit is ready. Do not point the unit at so u rc es o f heat , s uc h as r ad iat o r s, sp ac e h eat ers, etc . Adju st be a ms l at era ll y by s lidi ng th e L en s S uppor t hori zon ­tally within its retainers. Loosen the Height Lock Screw and set the board’s height scale to t he mo unted height o f the uni t . R etight en the screw. To block a proble m zone, appl y a piece of lens foil (supplied) to t he
inside
segment of the lens r epresen ting that zo ne. To ext ing uish th e LED aft er walk-testing, place a jumper in the LED Jumper position.
7
STANDARD LENS
o
85
6’
70’
LOOKDOWN
ZONE
(a) TOP VIEW (b) SIDE VIEW
Standard Lens coverage pattern.
Sales, Repairs and Technical Service (Toll Free): (800) 645-9445
57
RANGE POT
SSP JUMPER: ON=FIXED, OFF=SSP
70’
PIR1710 mounting and wiring.
Napco Security Systems, Inc.
333 Bayview Avenue, Amityville, N e w York 11701
Technical Service Direct Line (Toll Free): (800) 645-9440
WI882A 8/97
NA PCO SECURITY LIMITED WARRANTY
NAP CO SE CURI TY S ystems, Inc. (NAP CO) warrants its products to be free from manufacturing defects in materials and workmanship for twelve months following the date of manufacture. NAPCO will, within said period, at its option, rep air or replac e any pro duc t failing t o operate, without cha rge to the original purchaser or user.
In case of defect, contact the security professional or locksmith who installed and maintains your security system. In order to exercise the warranty, the product must be returned by the security professional or locksmith, shipping costs prepaid and insured to NAPCO. After repair or replacement, NAP CO a ssumes the cost of returning products under warranty. NAP CO shal l hav e no obligation under this warranty , or otherwise, if th e produ ct has been re paired by other s, imprope rly installed, imprope rly use d, a bus e d, a lt er ed, dam age d, subj e cte d to a cci den t, nui sa n ce, fl ood, fi re or a cts of G od, or on whi ch any s erial num bers have been altered , defac ed or remo ved. N APCO will n ot b e respo nsib le for an y dismantling , re assembly or reinstallation charges.
THERE ARE NO WARRANTIES, EXPRESS OR IMPLIED, WHIC H EXTEND BEYOND THE DESCRIP­TION ON THE FACE THEREOF. THERE IS NO EXPRESS OR IMPLIED WARRANTY OF MERCHANT ABILITY OR A WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE. ADDITIONALLY, THIS WARRANTY IS IN LIEU OF ALL OTHER OBLIGATIONS OR LIABILITIES ON THE PART OF NAPCO.
Any action for breach of warranty, including but not limited to any implied warranty or merchant ability, must be brought within the six months following the end of the warranty period. IN NO CASE SHALL NAPCO BE LIABLE TO ANYONE FOR ANY CONSEQUENTIAL OR INCIDENTAL DAMAGES FOR BREACH OF TH IS OR ANY OTHER WARRANTY, EXPRESS OR IMPLIED, EVEN IF THE LOSS OR DAMAGE IS CAUSED BY THE SELLER’S OWN NEGLIGENCE OR FAULT.
This warranty contains the entire warranty. It is the sole warranty and any prior agreements or rep resen tatio n s, wh eth er o ral o r wr itten , are eith er m erg ed herein or are exp res sly c anc eled. NAPCO neither assumes, nor authorizes any other person purporting to act on its behalf to modify, to change, or to assume for it, an y other wa rranty or liability conce rning its pro ducts.
In no even t sh all NAPCO be liab le fo r an amo unt in exc ess o f NAPCO’ s o rig inal se lling pric e o f the product , for the los s or dam age, w h ether di r ect, indi r ect, inci dental, con s eque n t ial, or other w ise ari s ing out of any failure of the product. Seller’s warranty, as herein above set forth, shall not be enlarged, dim in ish ed o r affec t ed b y, an d n o o b lig at io n o r liab ilit y s h all ar ise o r g r o w o u t o f, Seller ’ s r en d er ing o f technical advice or service in connection with Buyer’s order of the goods furnished thereunder.
NAPCO RECOMMENDS THAT THE ENTIRE SYSTEM BE COMPLETELY TESTED WEEKLY.
WARNING:
tampering, electrical or co mmunications d isruption, it is possible for the system to fail to perform as expected. NAPCO does not represent that the product/ system may not be comp romised or circum­vented; or that the pro duct or system will pr event any perso nal injury o r pr oper ty loss b y burglar y, robbery, fire or otherwise; nor that the product or system will in a ll cases p rovid e adequa te warning or prote ct ion. A pr ope r ly i ns t a lled an d ma intain e d alarm or lock ma y on ly re du ce r isk of bu rglar y , r obbe r y , fire or otherwise but it is not insurance or a guarantee that these events will not occur. CONSEQUENTLY, SELLER SHALL HAVE NO LIABILITY FOR ANY P ERSONAL INJURY, PROP ERTY DAMAGE, OR OTHER LOSS BASED ON A CLAIM THE PRODUCT FAILED TO GIVE WARNING. Therefore, the installer should in tu rn ad vis e th e c o n su m er , an d t he co n su m er is he reby advised, t o t ak e an y an d all p r ec au tio n s for his or her safe ty in cluding but n ot limited t o, flee ing the pr emises and calling police or fire dep a rtment , in order to mitigate the possibilities of harm an d/or damage.
NAPCO is no t an in s u r er o f eit h er t h e p r op er t y o r safety of the u s er ’s fam ily or emplo y ees, an d limits its lia b ilit y for an y lo s s o r dam ag e in c lu d in g in c iden t al o r co n s eq u en t ial dam ag e s t o N APCO’ s o r igin al selling price of the produc t re gardless of the cause of such loss or damage.
Some states do not allow limitations on how long an implied Warranty lasts or do not allow the exclusion or limit atio n o f in cid ent al o r c o nseq u ent ial dam ag es, or differ ent iate in th eir tr eat ment of lim itat io ns o f liabilit y fo r o rd in ar y o r gr o ss n eg lig en c e, so th e ab o ve lim it atio n s o r e xc lus io ns m ay n o t ap p ly t o y o u. This Warranty gives you specific legal rights and you m ay also have other rights which vary from state to state.
Despite frequent testing, and due to, but not limited to, any or all of the following: criminal
Loading...