NAPCO NP-DMOD-8OUT User Manual

R

333 Bayview Avenue

Amityville, New York 11701
For Sales and Repairs, [phone]
For Technical Service, [phone]

© NAPCO 2005

NP-DMOD-8OUT

8 OUTPUT

POWER DISTRIBUTION MODULE

WI1338B 12/05

DESCRIPTION

A Power Distribution Unit, the NP-DMOD-8OUT easily
converts a single AC or DC output power supply into
eight (8) individually fused outputs.

FEATURES

• Handles up to 28VAC/VDC.

• Converts a single AC or DC input into eight (8) indi-

vidually fused outputs (fuses rated @ 3 Amps may be
used).

• Power output LED indicator.

• Surge protected outputs.

• Board dimensions: 131.83mm(L) x 85.34mm(W) x

24.6mm(H)

INSTALLATION INSTRUCTIONS

1. Mount NP-DMOD-8OUT in desired location/
enclosure.

2. Connect the desired power supply output to termi­nals marked [INPUT].

Note: If using DC voltage, right terminal is NEG. (-)

and left terminal is POS. (+).

3. Connect each device camera to terminal pairs 1 to 8,
marked [+ thru -].

Note: It is important to measure output voltage be-

fore connecting devices. This helps avoid potential
damage.

All terminals with common suffix “+” are same polar-

ity.

4. Fuses rated at 3 Amps VAC.

APPENDIX LIST

Item Description Dimension Volume Memo

1 Instruction Sheet A4 1
2 Double Stick Foam Tape 60*20*7mm 2