NAPCO NP-DMOD-4OUT User Manual

R

333 Bayview Avenue

Amityville, New York 11701
For Sales and Repairs, [phone]
For Technical Service, [phone]

© NAPCO 2005

NP-DMOD-4OUT

4 OUTPUT

POWER DISTRIBUTION MODULE

WI1337A 12/05

DESCRIPTION

A Power Distribution Module, the NP-DMOD-4OUT
easily converts a single AC or DC output power supply
into four (4) individually fused outputs.

FEATURES

• Surge protected outputs.

• Conveniently converts a single AC or DC input into

four (4) individually fused outputs (fuses are rated @
3 Amps fuses may be used).

• Handles up to 28VAC/VDC.

• Power output LED indicator.

• Board dimensions: 131.83mm(H) x 85.34mm(W) x

28mm(D)

INSTALLATION INSTRUCTIONS

1. Mount the NP-DMOD-4OUT in desired location/

enclosure.

2. Connect the desired power supply output to termi­nals marked [INPUT].

Note: If using DC voltage, left terminal is NEG. (-)

and right terminal is POS. (+).

3. Connect each device to terminal pairs 1 to 4, marked
[1+ 1- thru 4+ 4-].

Note: It is important to measure output voltage be-

fore connecting devices. This helps avoid potential
damage.

All terminals with common suffix P 1+, 2+...” are

same polarity.

4. Fuses rated at 3 Amps.

APPENDIX LIST

Item Description Dimension Volume Memo

1 Instruction Sheet A4 1
2 Double Stick Foam Tape 60*20*7mm 2