Nanight Cave 2 User Manual

Page 1
User Manual Nanight Cave 2 Dive light
Thank you for choosing a dive light from Nanight! The lamp is designed for diving at depths of up to 200m. We at Nanight hope your new lamp will give you many rewarding days and nights of diving!
1 PRODUCT DESCRIPTION
Output: 4000 lumens
LED Type: Cree XHP70
Battery: 14,4V Panasonic Li-Ion, 6700 mAh,
Beam Angle: 5°
Burn Time: Up to 7 hours
3-step dimming
Operating temperature: 0 – 35°C
Operating voltage: 5 - 20V
2 NANIGHT CAVE INCLUDES THE FOLLOWING PARTS
Lamp head
Battery canister
Charger
HD Canister mount
Goodman handle
Velcro canister tank mount
Case and a sticker
3 BEFORE USE
3.1 CHARGE THE BATTERY
Open the battery canister by unscrewing the sealing plastic plug counterclockwise.
Disconnect the battery connector by pressing down on the latch and pull the connectors apart (see picture).
Connect the charger connector to the battery connector. It is important that the connectors are connected to each other in the correct orientation (see picture).
Plug the charger into a wall outlet. The charger's indicator light turns from red to green when the battery is fully charged.
When the battery is fully charged, disconnect the charger connector and reconnect the dive light connector. It is
important that the connectors are connected to each other in the correct orientation (see picture).
Inspect the o-rings, clean any debris and replace them immediately if damage exists.
Make sure that the elastics around the battery is tight and keeps cords and plugs in place.
Close the canister by pushing the plastic plug into the pipe, past the first o-ring. Tighten the plastic cap by turning
Clockwise. Be careful so that the parts threading properly against each other.
Page 2
3.2 ADJUST THE HANDLE
The Goodman handle is designed to sit comfortably and be easily adaptable in size. We recommend that the lamp be held in the manner shown below.
3.3 USAGE
The drop-shaped knob controls the functionality of the lamp. Loosening or tightening the screw can adjust wrath of inertia.
3.4 SWITCH THE LIGHT ON
Turn the knob clockwise. It will start at 75 %.
To check the battery charge status: turn the light on and
then off within 2 seconds, a number of short flashes indicate battery charge status:
Flashes
Battery Level
4
75-100%
3
50-75%
2
25-50%
1
5-25%
When the battery levels falls, the amount of light will automatically be reduced to save the battery, and allow the user to end the dive safely.
3.5 SWITCH THE LIGHT OFF
Turn the knob counterclockwise until it touches the locking position, the light will go off with a delay of 2 seconds.
Turn the knob counterclockwise past the locking position, to ensure that the light does not come by accident, for example during transport.
For SOS-function turn light on-off-on within 2 seconds
Page 3
3.6 DIM THE LIGHT
Turn the knob counterclockwise until it touches the locking position, and back again within 2 seconds. It will switch to full effect.
Repeat the maneuver for further dimming.
In this way, the light is dimmed gradually in three steps.
Note that the light automatically dims down to preserve battery level to make time to end the dive safely. See the burntime graf in the
previous section.
4 AFTER USE
4.1 MAINTENANCE
Rinse the dive light in fresh water after use.
Lubricate the seals with silicone grease if necessary.
Disconnect the battery if the light is not used for long
periods or when transporting by air.
Make sure the o-rings are clean from debris and undamaged. Replace o-rings if necessary.
5 WARNINGS AND PRECAUTIONS
When diving in dark water, a backup dive light should always be brought. Nanight Sport 2 is a great addition.
Nanight cave 2 is a bright light. Never direct the light directly into the eyes of yourself or others.
When using the dive light above water, it may become hot. Be careful not to burn yourself or others.
Do not disassemble the lamp head or battery-canister while they are still wet.
Do not recharge the battery if the water has penetrated into the battery canister.
6 RECYCLING
This product contains electronic components and must not be disposed of with household waste. Leave the product for recycling in designated areas, such as municipal recycling center.
7 WARRANTY
Provided the product is used as intended, 2 year of warranty is given on the lamp, and 6 months on the battery pack. The warranty is valid provided that a receipt of the purchase can be presented, and includes repair or replacement of defective parts.
8 CONTACT INFORMATION
Nanight AB support@nanight.se
http://nanight.se
For further information, please visit http://nanight.se
Loading...