Namco Controls Proximity Sensor Wiring Diagrams

Typical
4
L2
L2
Proximity
Wiring Diagrams
1. These diagrams are valid for sensors with cables and connectors.
2. Sensors may or may not have ground connections or grounded housings. Refer to the specific connector or cable diagram for your particular sensor’s model number to determine if it is grounded.
3. The markings on these wiring diagrams (L1, Load, etc.) are identical to those on the connector diagrams.
4. All switches are Normally Opened (N.O.) unless specifically marked
Proximity Sensors
Normally Closed (N.C.).
5. All switch outputs are Sourcing unless specifically marked Sink.
AC Wiring Diagrams
Sensors
2-wire AC
-wire AC
L1
L1
L1
L1 LT
L1 RT
SENSOR
GND
SENSOR
LOAD
LOAD LT
LOAD RT
LOAD
LOAD
LOAD
Namco • 2013 West Meeting Street • Lancaster, SC 29720 • 1-803-286-8491 • FAX: 1-800-678-6263
98
DC Wiring Diagrams
2 S
* S S
-DC
-DC
3 S
2 S
3 S
4 N
+DC
-wire DC ourcing (PNP)
-wire DC inking (NPN)
+DC
SENSOR
GND
LOAD
LOAD
LOAD
SENSOR
-DCLOAD
Proximity Sensors
GND
-wire DC ourcing (PNP)
+DC
SENSOR
-DC LOAD
LOAD
-wire DC inking (NPN)
LOAD
+DC
LOAD
SENSOR
-DC
4-wire DC
ink (NPN)/ ource (PNP)
LOAD
+DC
SINK
-DC
SENSOR
SOURCE
LOAD
N.O.
-wire DC (PNP)
.O./N.C.
+DC
SENSOR
-DC N.C.
+DC
* Can be used as a single sink or source switch. When both outputs are used simulta­neously, the sum of the load currents must not exceed maximum rating of sensor!
LOAD
LOAD
2013 West Meeting Street • Lancaster, SC 29720
1-803-286-8491 • FAX: 1-800-678-6263
www.namcocontrols.com
For technical assistance, call 1-800-NAMTECH
99
Loading...