NAMCO Bandai Games 90500023 User Manual

Operators Manual

Part No 90500023

Page 1

1. SPECIFICATIONS

POWER SUPPLY :- 220/240volts AC

MONITOR :- Hantarex 28" Polo Colour Monitor with auto
degauss.

DIMENSIONS :- 790(w) x 1200(d) x 2080(h)

WEIGHT :- 175kg.

ACCESSORIES :- Keys: (Cash Door) ................. 2

(Coin Door) .................. 2

(Back Door).................. 2

IEC Mains Lead ............................... 1

Operators Manual ............................ 1

Monitor Manual ................................ 1

1P - Punch Button 2

1P - Punch Button 1

1P - 8way Joystick

1P - Kick Button 1

1P - Kick Button 2

2P - Punch Button 1

2P - 8way Joystick

2P - Punch Button 2

2P - Kick Button 2

2P - Kick Button 1

Page 1

2. PRECAUTIONS

2-1 Cautions When Installing.

This game is designed for indoor use only. The game must not be installed

outdoors or

under the following conditions:­a. In areas directly exposed to sunlight, high humidity, direct water contact,

dust, high heat or extreme cold.

b. In locations that would present an obstacle in the case of an emergency,

i.e. near fire equipment or emergency exits.

c. On an unstable surface or subject to floor vibration.

2-2 Cautions when Handling.

a. AC power must always be turned OFF, and the game disconnected, before

replacing any parts or connecting/disconnecting connectors.

b. When unplugging the game from an electrical outlet, always grasp the

plug, not the mains lead.
c. The machine must be earthed with a securely connected earthed plug.
d. Care must be taken at all times to avoid electric shock when inspecting or

adjusting the game.

2-3 Cautions when Transporting.

a. Do not subject the game to physical shock when transporting or moving it.
b. Always return the levellers to the UP position before moving the machine.
c. Take care not to rope any moulded (plastic) parts when transporting.

2-4 Cautions when handling the PCB.

a. Never test the PCB for continuity with a multimeter or similar device. The

PCB contains sensitive devices which could be damaged or even

destroyed by the internal voltage of such test equipment.
b. Foreign matter or dust on the PCB may cause failure. Turn off the power

and clean the PCB with a dry soft brush.
c. When transporting the PCB ensure adequate packing protection to prevent

damage.

Page 3

3. ADJUSTMENTS

3-1 Turning on the Power

After installing the machine, turn on the power. The power switch is located
above the mains inlet on the rear of the cabinet.

3-2 Switches for Adjustment

Open the coin door to find the switches for adjustments, located on the service
bracket.

1. Service Switch
Press this switch to obtain game credits without incrementing the coin

counter.

2. Test Switch
Slide this switch "ON" to enter test mode.

Test mode allows game testing and the changing of game settings.

(See "3-4 Test Mode" on page 5)

There are two DIP switches located on the PCB.
Switch 1 when set ON will enter the game into test mode. Always ensure this
switch is set to OFF and use the test switch on the service bracket for testing
the machine. Switch 2 when set ON will freeze the screen.

3-3 Volume Adjust

The volume control is located on the PCB. Turn the control to increase or

decrease the

volume.

SERVICE BRACKET

COIN COUNTER

TEST SWITCH

SERVICE SWITCH

Page 4