Please refer to the 500GP Operation Manual for general installation details.
3-1Play Zone
Set a play zone as illustrated below to prevent contact between players and observers.
The clearance between the floor and ceiling must be at least 2m 30cm.
To enable access for service and maintenance, allow a clearance of at least 50cm
between the game and walls or other equipment.
Approx. 50cm
or more
Provide a small space (approx. 2cm) between adjacent
cabinets to prevent screw heads touching each other.
Approx. 2cm
Approx. 50cm
or more
or more
Approx. 50cm
Approx. 3m 70cm or more
Play zone
Pathway
Page 10
or more
Approx. 50cm
Approx. 1m or more
3-2Cabinet Order
When Setting the cabinets together ensure that the YAMAHA Bike is on the left
(as viewed from the front), the HONDA bike is in the centre and the SUZUKI bike is on
the right.
Page 11
4.MAINTENANCE
4-1Replacing the Signal (H) Fluorescent
Refer to the 500GP Operation Manual section 9-2-2 page 82 for general procedures.
1. Remove 4off torx screw (M5x12) and remove the signal cover (C).
2. Replace the fluorescent tube or starter.
3. Reassemble in reverse order.
Note: Do not remove the 4off screws retaining the signal acrylic as this will not give access
to the flourescent tube or starter.
Signal cover C
Signal Acrylic
See Note
Torx screw
(M5x12)
Page 12
5.OPERATION
5-13 Monitor Mode
The 3 monitor mode allows only a single player to play the game using the centre bike
with the course displayed accross all three projection screens.
1 To select 3 Monitor Mode enter ‘OTHER’ in the test mode, Set ‘3 Monitor Mode’ ON
on all three games.
2. Set the ‘CPU ID’ in ‘Game Options’ of the test mode as follows:
YAMAHA (left)1 Blue
HONDA (centre)2 Red
SUZUKI (right)3 Yellow
3. Ensure that the settings for all 3 bikes are the same, i.e. difficulty, lap number etc.
(see section 5-3-5 page 27 and section 7-8 page 45 in the 500GP Operation Manual for
details of the Test Mode and how to link games.)
When using this mode it is important to note the following:
• Only the centre bike (HONDA) is playable. The left (YAMAHA) and right (SUZUKI)
bikes do nort work.
Neither the left or right bikes count coins. Please cover the coin entries on these
bikes to prevent players inserting money accidentally.
• The engine sound will only come from the centre bike (HONDA).
• The ‘How to Play Instructions’ in the attract mode is different on the centre screen
from the left/right screens.
Page 13
6.PARTS
The following lists of parts only show those parts that are specific to the 3 in 1 game.
Refer to the 500GP Operation Manual for all other parts.
6-1-1Ride Assy (H) HONDA
All parts are as shown in the 500GP Operation Manaual.