Nady Systems 351VR User Manual
NADY 351 VR
351VRman 10/17/01 9:33 AM Page 1
4
NADY 351 VR RECEIVER
• Ultra-compact receiver can be camera mounted or worn on the body (with
attached clip).
• Easy hookup to camcorder with supplied connecting cable
• Powered by a 9V Alkaline battery in a convenient “slide open” battery
compartment
• LED lights indicate low battery and receiver signal
• Detachable softwire antenna extends from the top of the receiver
• Convenient operation with Output Level and Mute Adjusts, separate
3.5mm Audio Output and Monitor Headphone mini jacks and Headphone
Volume thumbwheel control with integrated unit OFF/ON switch
Operating Instructions
Powering the Receiver
Slide the receiver’s battery cover open and place a fresh 9V battery in the
BATTERY COMPARTMENT (1), observing the correct polarity. (Although a
fresh alkaline battery can last up to 8-10 hours in use in the receiver, in
order to ensure optimum performance it is recommended that the receiver
battery be replaced after 5 hours use.) Turn the receiver on by rotating the
ON/OFF/VOLUME WHEEL (2) clockwise. The LOW BATT LED (3) will
flash briefly, indicating adequate battery strength. If the LOW BATT LED
lights during use, replace battery.
Antenna
When the system is in use, the 351 VR receiver’s standard wire Antenna
should be fully extended to obtain maximum range. You may also install
Nady’s optional rubber duck or flexible rubber duck antenna. They all
simply screw into the ANTENNA SOCKET (4) on top of the receiver.
Mute Adjustment
In normal operation, the MUTE CONTROL (5) on the back of the receiver
should be set fully clockwise to the factory preset RF level of 1 µV.
However, in areas of high RF activity, the mute may need to be adjusted. If,
with transmitter off, the receiver’s “TX” LED (6) flickers or stays on, the
MUTE control should be turned counter clockwise until the “TX” LED
extinguishes.
When the mute is properly adjusted, the “TX” LED will light only when the
system transmitter is turned on.
Note: Turning the MUTE control too far counter
clockwise will yield a quieter mute function, but reduce your operating range.
3
Thank you for purchasing a Nady 351 VR wireless camcorder microphone
system—and congratulations on your choice. The 351 VR operates on longrange interference-free VHF high band frequencies. It also utilizes a patented
companding noise reduction system for excellent dynamic range (120 dB) and
hiss-free performance. The 351 VR will make a tremendous difference in your
videos, adding professional quality audio to every production.
Using this Manual
Please read these instructions completely before operating your unit. This
booklet gives instructions for the operation of the Nady 351 VR wireless
system which consists of a wireless receiver, an audio cord to connect the
receiver to your camcorder, and a wireless microphone transmitter—either the
WLT-15 lavalier or Nady WHT-15 handheld.
TABLE OF CONTENTS
Using this Manual ..................................................................3
351 VR Receiver ..................................................................4
WLT-15 Lavalier Bodypack Transmitter ................................6
WHT-15 Handheld Microphone Transmitter ..........................8
Specifications ......................................................................10
Service ................................................................................10
351VRman 10/17/01 9:33 AM Page 2
Loading...