NaceCare Solutions NA20SS User Manual

Owners Manual for NA Floor Machines and High Speed

Burnishers

SERVICE INFORMATION

To obtain consistent performance over the
lifetime of your NaceCare equipment, read
through these instructions and save them for
future reference.

The model and serial number can be found
on the nameplate located on the side of the
handle. If you require service, or need to
make an inquiry about the machine, please
have this information ready when calling.

IMPORTANT SAFETY
INSTRUCTIONS

When using an electrical appliance, basic
precautions should always be followed, including
the following:

Warning: Electric shock
can cause serious injury
or be fatal. Please read
the following
instructions on the use
and operation of these
machines.

Your floor machine is equipped with a safety

switch lock and power switch triggers
designed for your safety. Do not attempt to
bypass or defeat the safety switch lock.
Never use any device to lock the power
switch in the “ON” position.

Do not leave the floor machine when plugged in.

Make sure that the machine unplugged when not
in use, and before servicing or changing the
brushes or pads.

Do not allow the machine to be used by a child.

Close attention is necessary when used near
children. Do not leave the machine plugged in
while unattended.

Use only as described in this manual.
Do not use the machine with a damaged cord or

plug. If the machine is not operating as it should,
discontinue use immediately and contact a
service center.

When operating, pay close attention to the

location of the electrical cord. Do not let the
brush/pad driver come into contact with the
electrical cord.

Do not pull the cord around sharp corners or

edges. Keep the cord away from heated surfaces.

Connect to properly grounded outlet only.
Do not use extension cords or outlets with

inadequate current carrying capacity.

Turn off all controls before unplugging.
Do not unplug the machine by pulling on the

cord.

Do not handle the plug or floor machine with wet

hands.

Use extra care when working near stairs
Do not use with or near flammable or

combustible liquids or gasses.

Use indoors only
Always keep your work area well lighted.