NaceCare Solutions AV12QX User Manual

Owners Manual for the AV12QX

PRIOR TO USING THIS MACHINE, MAKE SURE THAT YOU HAVE READ, AND
UNDERSTAND THE SAFETY AND OPERATING INSTRUCTIONS FOR THIS MACHINE.

NaceCare Solutions

1205 Britannia Road East

Mississauga, Ontario, Canada

L4W 1C7

Toll Free: 1 800 387 3210

Toll Free Fax: [phone]

Safety instructions (read carefully)

Every electrical device must be used for its particular function only, respecting the manufacturer’s
instructions. Failure to adhere to these instructions could result in serious bodily injury to the operator
(shock, electrocution, etc.).
Please read the following safety instructions carefully and ensure that you understand them prior to
using the machine.

• Before putting the machine’s plug in the wall socket, check that the voltage available is the same
indicated on the label of the machine.

• Be sure that the electrical system is well grounded and that it has a GFI.

• Verify that the cable plug is the same as the outlet.

• Do not use adapters or multiple sockets

• If any electrical extension is used, ensure it is the correct gauge of wire and make sure it is

watertight.

• Take care of the electrical cable. Do not repair the cable in case of tears, but replace it with a new
one.

• Do not pull the cable to drag the machine or to pull the plug out. Pull the plug out only when the
machine is switched off.

• Do not handle the plug with wet hands.

• Do not spray water near electrical outlets. Do not use the machine to spray or to suck dust,

corrosive liquids (acids or bases) and explosive or inflammable liquids.

• Do not use the machine in an explosive atmosphere.

• Do not let the machine be used by children and people unable to understand the danger

connected with the use of electrical power.

• Do not bring the end of the suction hose or one of the accessories near your face or others’,
particularly near ears and eyes: the sucked air could seriously damage them.

• If the machine is used as a wet vacuum cleaner, you must check the level of water in the recovery
tank, in order to prevent water from being sucked through the vacuum motor.

• If the chemical you are using produces foam, or if you are cleaning carpet previously treated with
shampoo, you must

add defoamer into the recovery tank to prevent damage to the vacuum

motor.

• In case of abnormal working (very noisy motor, pump not running, extreme temperature rise, or
other suspicious signals) switch off the machine and pull the plug out.

• After using, store the machine, well cleaned, in a cool and dry place.

Attention:

all electrical repairs must be performed by qualified personal only!

2

SETUP

This machine is designed to clean large areas of carpet. For normal operation, the machine drives
forward, cleaning a path of 20 inches of carpet (see Using as a Self-propelled Machine
It can also be used to clean small areas of carpet, with an additional hose and floor wand (see Using
with Accessories)

The following steps explain how to prepare the machine for use:

1. Fill in the lower tank (solution tank) with cold or warm water, through the filling hole, adding

chemical according to the manufacturer’s specifications.

).

Attention: wool carpet must be washed with cold water only!

2. Plug the power cord into the wall outlet (see Safety Regulations

3

).