Mytee Contractor’s Special 2000CS, Contractor’s Special 2001CS Instructions Manual

Instructions for

Contractor’s Special™ 2000CS

Please read before use.

Register your product
at www.mytee.com/help

&6S
*HQHUDO0DLQWHQDQFHLQIRUPDWLRQS

Model #

Serial #

Form # ADM-CS

3-12

13655 Stowe Dr., Poway, CA. 92064

1

CONTRACTOR’S SPECIAL™ 2000CS

7

6

1. Waist high controls

2. 2” Male Cuff-Lynx™

3. Female QD

4. Solution tank

5. Front vent

6. Solution lid

7. Push handle

2000CS FRONT

2000CS BACK

1

8

2

3

4

13

12

14

9

5

11

8. Recovery tank lid

9. 3” casters

10. 8” wheels

11. Rear vent

12. 25’ Power cord

13. Bucket-high drain valve

14. Recovery tank

10

2000CS ACCESSORIES

8300 EZ C - 12” Wand

H226 - Drain Elbow

8501- 15’ 1-1/2” Vac/Sol Hose

H141 - 1 1/2” Cuff-Lynx™

REPLACING HOSE CUFFS WITH CUFF-LYNX™

Twist clock-wise to remove standard cuffs.

Twist counter clock-wise to attach Cuff-Lynx™ to vac. hose.

Once you receive your Contractor’s Special™, you will need to
replace the cuffs on your vacuum hose. To remove old cuffs, twist
clock-wise. To attach reducer Cuff-lynx™ to vacuum hose twist
counter clock-wise.

2

CONTRACTOR’S SPECIAL™ 2000CS

2000CS ATTACH HOSES

Firmly attach hose and quick disconnect. Make sure quick discon­nects snap together rmly. Once attached to unit connect Q.D. to
upholstery tool. Always inspect hoses for cracks or fraying.

ATTACH VAC & SOLUTION HOSE TO WAND

Attach hose cuff to end of wand tube. Attach female QD to male
QD located near the wand trigger.

2000CS FILL SOLUTION TANK

Lift lid to ll. For best results, ll with warm water (140o F).

2000CS VACUUM & PUMP

VACUUM PUMP

To use vacuum, turn on vacuum. To use pump, turn on pump.

3