Mytee A600 Assembly Instructions Manual
A600 Shelving System
This package includes:
Assembly Instructions
x6
Shelf Supports
(part # P642)
x2 x2
Floor Mount Brackets
(part # H162A)
A B
x24 x16 x40
#14 x 2" Screws
(part # H672)
(actual size shown)
Wall Anchor Brackets
#14 x 1.25" Screws
(part # H671)
(actual size shown)
x12
Cross Bars
(part # H175)
(part # H346)
.25" Flat Washers
(part # H210)
(actual size shown)
Tools required for assembly:
#3 Phillips Head Screwdriver
or
Drill with #3 Phillips Head Bit
ADP-A600 REV. 07/30
Assembling the A600 Shelving System
A
1. Insert four (4) shelving tubes into the four lower slots on
one of the side panels.
A
3. Place another side panel on the opposite end of the
shelving rods. Make sure each rod is inserted into the
correct slots and screw into place using the 2” A screws
and .25” washers.
Repeat steps 1-3 two more times.
2. Screw each shelving tube into place using one of the
2” A screws with a .25” washer. Screws should line up
with the pre-drilled holes on the tubes.
B
4. Take one of the assembled shelves and slide a oor
mount bracket onto the bottom with the ange pointing
outward. Screw into place with the 1.25” B screws and
.25” washers. Do the same on the other side of the shelf.
CAUTION: Do not overtighten.
B
5. Turn the bottom shelf upright and stack the other two
shelves on top of it. Screw each shelf together using the
1.25” B screws and .25” washers.
B
6. Place the shelving unit in position in the van. The in-
cluded wall anchors can be attached to the top or middle
shelf, on the inside or outside of the supports. Screw
the anchors in place using the 1.25” B screws and .25”
washers. CAUTION: Do not overtighten. Screw the an-
chors and oor brackets into the van. Hardware will vary
depending on the van’s design.
ADP-A600 REV. 07/30
Loading...