Mytee 8070 Instruction Manual & Safety Manual

CONGRATULATIONS!

Thank you for choosing Mytee Products for your supply needs. By doing so, you have joined
thousands of your fellow cleaning professionals in choosing quality, service, and value in your
equipment.

This manual is designed to help you with the setup, maintenance, and operation of your new unit.
Please read and review it carefully before using the equipment for the first time. It also contains
information on optional accessories, cleaning tips, and a troubleshooting guide.

We here at Mytee Products would like to welcome you to the team, and wish you the best for the
future.

TABLE OF CONTENTS

Safety Precautions 2
Warranty 3
Unpacking The Machine 4
Optional Accessories 5
Attaching Handle 5
Setup 6
Operation 9
Tips 10
Draining Recovery Tank 11
Maintenance 12
Troubleshooting Guide 13
Replacement Parts 15

SAFETY PRECAUTIONS

This machine is intended for commercial use. It is designed to clean carpet and upholstery in an indoor environment
and is not constructed for any other use. Use only recommended cleaning solutions and accessory tools. All
operators must read, understand and practice the following safety precautions:

WARNING: Flammable materials can cause an explosion or fire. Do not use flammable

materials in tank(s).

FOR SAFETY:

1. Do not operate machine:

♦♦♦♦ Unless trained and authorized.

♦♦♦♦ Unless operator manual has been read and understood.

♦♦♦♦ In flammable or explosive areas.

♦♦♦♦ Unless cord is properly grounded.

♦♦♦♦ With damaged cord or plug.

♦♦♦♦ If not in proper operating condition.

♦♦♦♦ In outdoor areas.

♦♦♦♦ In standing water.

2. Before operating machine:

♦♦♦♦ Make sure all safety devices are in place and operate properly.

3. When using machine:

♦♦♦♦ Do not run machine over cord.

♦♦♦♦ Do not pull machine by plug or cord.

♦♦♦♦ Do not pull cord around sharp edges or corners

♦♦♦♦ Do not unplug by pulling on cord.

♦♦♦♦ Do not stretch cord.

♦♦♦♦ Do not handle plug with wet hands.

♦♦♦♦ Keep cord away from heated surfaces.

♦♦♦♦ Report machine damage or faulty operation immediately to your distributor.

♦♦♦♦ Follow mixing and handling instructions on chemical containers.

4. Before leaving or servicing machine:

♦♦♦♦ Turn off machine.

♦♦♦♦ Unplug cord from wall outlet.

5. When servicing machine:

♦♦♦♦ Unplug cord from wall outlet.
♦ Avoid moving parts.

♦♦♦♦ Do not wear loose jackets, shirts, or sleeves.

♦♦♦♦ Use manufacturer supplied or approved replacement parts.

WARNING: Hazardous Voltage. Shock or electrocution can result. Always unplug

machine before servicing.

Machine must be grounded. If it should malfunction or breakdown, grounding provides a path of least
resistance for electrical shock. This machine is equipped with a cord having an equipment-grounding
conductor and grounding plug. The plug must be plugged into an appropriate outlet that is properly
installed in accordance with all local code and ordinances. Do not remove ground pin; if missing, replace
plug before use.

WARNING: Flammable materials or reactive metals can cause an explosion or fire.

WARRANTY

Mytee Products, Inc. endeavors to provide high quality products and product support to its customers and therefore backs up all of its new
products purchased from Mytee Products Inc. (“Mytee”) or any authorized Mytee distributor/service center with this limited warranty. This
limited warranty begins on the date of the customer’s purchase and is valid and available to the original purchaser only. Mytee’s products are for
commercial use only and are not intended for personal, family or household uses.

HOWEVER, OTHER THAN SET FORTH HEREIN, MYTEE GIVES NO WARRANTY, EXPRESS OR IMPLIED, AS TO DESCRIPTION,
QUALITY, MERCHANTABILITY, FITNESS FOR ANY PARTICULAR PURPOSE, PRODUCTIVENESS, INFRINGEMENT, OR OTHER
MATTER, OF ANY GOODS WHICH MYTEE SHALL SUPPLY. THERE ARE NO WARRANTIES WHICH EXTEND BEYOND THE
DESCRIPTION ON THE FACE HEREOF. MYTEE SHALL IN NO WAY BE RESPONSIBLE FOR THE PROPER USE AND
APPLICATION OF THE GOODS. MYTEE NEITHER ASSUMES NOR AUTHORIZES ANY OTHER PERSON TO ASSUME FOR
MYTEE ANY OTHER LIABILITY IN CONNECTION WITH THE SALE OF MYTEE’S GOODS. THIS LIMITED WARRANTY POLICY
MAY BE CHANGED OR WITHDRAWN BY MYTEE AT ANY TIME WITHOUT NOTICE.
WEAR PARTS 90-DAY LIMITED WARRANTY: Mytee will replace all wear parts for 90 days from the date of original purchase. “Wear
parts” are items which wear out as a result of usage or the passage of time and are consumed despite attempts to maintain them, such as gaskets,
wheels, brass, cords, wires, electrical terminals, hoses, switches, thermostats, plastisol parts, filters, bearings, brushes, solenoids, o-rings, bulbs,
heating elements, castors, or other parts deemed wear items in Mytee’s sole discretion. This warranty covers the cost of replacement only and
does not cover shipping or labor costs.

PUMP, VACUUM MOTOR AND HEATER 1-YEAR LIMITED WARRANTY: Mytee warrants that pumps, vacuum and floor machine
motors, and heaters will be free from manufacturing defects, defects in workmanship, and defects in material for one (1) year from the date of
original purchase. This warranty does not apply and is void if the pump, vacuum motor, or heater has worn brush motors, water damage,
chemical build-up, chemical damage, or evidence of abuse, neglect or tampering. This warranty covers the cost of replacement or repair only and
does not cover shipping or labor costs.

HOUSING 5-YEAR LIMITED WARRANTY: For five (5) years from the date of purchase, Mytee warrants a percentage of the cost of
replacement of rotationally-molded housings pro-rated as follows: Mytee will pay 100% of replacement cost in the first year from the date of
purchase, 75% of replacement cost in the second year from the date of purchase, 50% in the third year, 25% in the fourth year, and 12% in the
fifth year. Replacement cost does not include the cost of shipping or labor.

LIMITATION OF DAMAGES: THE REMEDY OF REPLACEMENT OR REPAIR OF ANY DEFECTIVE GOODS SHALL BE THE
EXCLUSIVE REMEDY UNDER ANY WARRANTY MADE BY MYTEE, WHETHER EXPRESS OR IMPLIED. IN NO EVENT SHALL
MYTEE BE LIABLE FOR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES, PROPERTY DAMAGES, OR PERSONAL INJURIES.

All limited warranties are void for, and Mytee does not warrant in any way, any product that evidences misapplication, improper installation,
abuse, lack of maintenance, negligence in use or care, abnormal use, alteration of design, use of incompatible or corrosive chemicals, use in a
rental service, and/or servicing, installation of parts, or repairs by anyone other than Mytee or a Mytee authorized distributor or service center.

Mytee may make changes in products it manufactures and markets at any time; these changes are made without obligation to change, retrofit, or
upgrade any product previously sold or manufactured. Mytee has no obligation to honor the limited warranties set forth herein unless the original
purchaser, promptly upon discovering the warranty claim and prior to continuing to use the product, contacts Mytee or a Mytee authorized
distributor or service center to describe the claim and to receive and follow instructions for documenting and resolving the claim. In addition, the
purchaser must provide the product to which the claim applies to Mytee or a Mytee authorized distributor or service center for a thorough
inspection.

If any provision or portion of this limited warranty policy is found to be unenforceable, then the remaining provisions and portions shall remain
valid and enforceable. If any provision or portion of this limited warranty policy is found to be limited by law, then that provision or portion shall
be construed to make it effective within the bounds of law. For example, if there are legal limitations on the duration of warranties, the
warranties made herein shall be construed to have the minimum duration required by law, or, if there are legal limitations of exclusion of
remedies, the exclusions made herein shall be construed to apply to the fullest extent possible without violating the law.

The validity, construction and performance of this warranty policy shall be governed by the laws of the State of California, without respect to
conflicts of laws principles. The exclusive jurisdiction of any legal action arising from or related to this warranty policy shall be in the State of
California and no legal action shall be commenced elsewhere.

UNPACKING THE MACHINE

Before unpacking the machine, inspect all boxes and pallets for signs of shipping damage. Please be aware that all
packages leave Mytee Products in perfect condition. Any equipment or carton damage caused during shipping is the
responsibility of the freight company, and should be handled by filing a claim with the carrier.

3” Stainless Steel Upholstery Tool

Mytee Lite II Unit

Quick Start Guide (1 Ea.)

Handle

Bolts and Washers for Handle

15’ Vacuum and Solution Hose

OPTIONAL ACCESSORIES

The following accessories and tools are available for this unit, and can be purchased separately at your local Mytee
dealer. You can find more information on any of them at www.mytee.com.

System Maintainer Machine

Rinse (3601)

Crevice tool (8700)

Collapsible wand (8390)

ATTACHING HANDLE

Step 1 – Put washers on bolts as pictured.

Step 2 – Thread all four bolts into the inserts on back of machine by hand.

Step 3 – After threading by hand, use a 7/16 wrench to tighten (Do not over tighten)