MySmartBlinds BC 015 User Manual

SMART SWITCH

User’s Manual

This product is to be used with the

MySmartBlinds automation kit.

TM

TABLE OF CONTENTS

SAFETY INFORMATION 4

PARTS IDENTIFIER 6

ABOUT THE SMART SWITCH 6

INSTALLATION 7

PAIRING TO THE APP 8

USING THE SMART SWITCH 10

LIMITED WARRANTY 12

SAFETY INFORMATION

CAUTION

Read all warnings and instructions prior to installing
the MySmartBlinds Smart Switch.

CAUTION

Do not use the Smart Switch for anything other than its
intended purpose. Any usage of any part of the Smart
Switch outside of its intended purpose is not covered
by the warranty.

FCC STATEMENT:

This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:

1. This device may not cause harmful interference,
and

2. This device must accept any interference received,
including interference that may cause undesired
operation.

Warning: Changes or modications not expressly

approved by the party responsible for compliance could
void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a partic­ular installation. If this equipment does cause harmful
interference to radio or television reception, which can
be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by
one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment
and receiver.

• Connect the equipment into an outlet on a circuit
different from that to which the receiver is con­nected.

• Consult the dealer or an experienced radio/TV tech­nician for help.

RF WARNING STATEMENT:

The device has been evaluated to meet general RF

exposure requirement. The device can be used in porta­ble exposure condition without restriction.

4 5