My Music Group T22 User Manual

manual

PAIRING BOTH EARBUDS:

1. Keep the distance between the cell phone and Metro within 3 feed(for pairing only)

2. Press and hold the multifunction button on both earbuds until you hear the prompt”Power

On”. You will then hear the prompt “Pairing”. You will hear 2 chimes to indicate both earbuds
are ready to paiting.

3. Active the Bluetooth function of the pairing device and select “Tzumi-Metro TWS” from

device list displayed

4. You will hear “Device Connected”. Your earbuds are now paired successfully.

SINGLE EARBUD PAIRING:
Press and hold the multi-function button for a few seconds until you hear 2 chimes it means
earbuds go to pairing mould, then active the device Bluetooth function to select “Tzumi-Metro
TWS” from the list, once you hear “Device Connected” it means the earbud ready to use.

CONNECTING TO OTHER BLUETOOTH DEVICES
NOTE:Your Metro can only be connected to one Bluetooth device at a time.

Noted:

1. Factory default seeting is RIGHT Earbud as MASTER Earbud. Once end user want to

reset/change MASTER Earbud, hold multi-function button on BOTH earbuds for 6seconds
when the lights begin to flash blue and red meanwhile you hear 2 chimes, quick press the
multi-function button 2x on the earbud you want to be the primary one.

2. If your Metro aren’t pairing to each other, they will need to be reset according to above

quide.

EARBUDS CONTROLS:

LISTENING TO MUSIC
Power ON/OFF- Press and hold multi-function button
Play music-Press multi-function button
Pause/resume music- short press master multi-function button
Next Track-short press the follower earbud

MAKING AND RECEIVING CALLS(MASER EARBUD ONLY):
Answer/end call- press multi-function button
Reject call- press and hold multi-function button
Redial last call – press twice quickly on the multi-function button

To Power Off Earbuds-2 ways:

1. Press the power button for a few seconds once hear prompt “Power Off” and both earbuds

will turn off.

2. Place earbuds in charging case both earbuds will turn off automatic

Charging the earbuds: Put both earbuds into charge casing.

Spec:

Sensitivity­Frequency:20-20KHz
Bluetooth Version: BT4.2
Standby Time: Up to 60hours
Continuous Play Time- up to 2.5hours
Charging time: 1.5hours(Earbuds)/2hours(case)
Battery:3.7V 50mAh(Earbuds)/ 3.7V 450mAh(Case)
Input:DC5V 50mA(earbuds)/ DC5V 500mA(case)

NOTE: This equipment has been tested and found to comply with
the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are
designed to provide reasonable protection against harmful
interference in a
residential installation. This equipment generates uses and can
radiate radio
frequency energy and, if not installed and used in accordance with
the instructions,
may cause harmful interference to radio communications. However,
there is no
guarantee that interference will not occur in a particular installation.
If this
equipment does cause harmful interference to radio or television
reception, which
can be determined by turning the equipment off and on, the user is
encouraged to
try to correct the interference by one or more of the following
measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from

that to which the
receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help

Changes or modifications not expressly approved by the party