TRUE WIRELESS EARBUDS WITH CHARGING CASE
RT-18
USER MANUAL
WHAT’S INCLUDED
1×Charging box
2×Earbud(L&R)
1×Charging Cable
1×Instruction manual
BLUETOOTH PARING INSTRUCTION
1. Pick up two earbuds from charge casing to power on, you will hear “power
on” meanwhile two earbuds flash blue LED light, after seconds it will be
paired automatically at the same time will hear 2 chimes ”dong dong” from
two earbuds
2. Keep the distance between the device and earbuds within 10 meters. (For
Bluetooth paring only)
3. Turn on the Bluetooth function on your device, search and select the
Bluetooth code “Soundmates”.
4. You will hear “device connected” Indicating that Soundmates are now ready
to use.
Remark: two ways to reset earbuds.
If your Soundmates aren’t pairing to each other, you need to put them in the
charge casing then pick up them and it will auto pairing.
FUNCTIONS
Power on: Pick up two earbuds from charge casing
Power off: Put back two earbuds into charge casing.
MUSIC/CALL
1. Previous/Next song
When music is playing, tap left earbud for three times to go to the previous
song, tap right earbud for three times to go to the next song.
2. Play/pause
Tap right earbud twice to play/pause music.
3. Answer /End an incoming call
Tap right/left earbud twice to answer a call, and tap right/left twice again
when you want to end the call.
WAKE UP VOICE ASSISTANT/SIRI
Tap left earbud twice, you will hear a beep to tell you that VA/Siri has woken up and
is waiting to do your conmmands.
CHARGING
(Be sure fully charge the earbuds before use for the first time.)
Charging the box:
-Plug the standard USB charging cable into the charging box and a powered USB port.
The charging box’s LEDindicators start to flash GREEN while charging.
It fully charged when it stop flash and keep GREEN on.
Charging the earbuds:
-Put the earbuds back into the charging box.
The earbuds LED indicators turn RED and the charging box LEDindicators turn BLUE,
both of them will be off when earbuds fully charged.
SPECIFICATIONS
Bluetooth Version: 5.0
Battery built-in earbuds: 30mAh*2, 3.7V
Charging box battery: 250mAh, 3.7V
Power output: 6mW
Charging time for earbuds: 1H
Charging time for station: 1H
Music play time: about 3H at Max volume
Talking time: about 3H
Frequency: 20-20KHZ
Product size: 51.5*44*21MM
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
Changes or modifications to this unit not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not -- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.occur in a
particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
This device and its antenna(s) must not be co-located or operation in conjunction
with any other antenna or transmitter.
The device has been evaluated to meet general RF exposure requirement. in portable
exposure condition without restriction.
Loading...