My Music Group LC D201 User Manual

Bluetooth Speaker

■ Bluetooth Instruction(Note: The Bluetooth code is LC-D201 , pair code: 0000)

1. Switch the button to “ON”, hear the prompt sound and the blue indicator flash, it
means it has entered Bluetooth paring status.

2. Starting up the Bluetooth function of mobile phone to search for Bluetooth
device.LC-D201, select it and it will be prompted for a password (Note: some
mobile phone can be connected directly without entering pairing code), enter
“0000”, press “Yes” to connect

3. The Bluetooth speaker is ready for use.

4. Switch the button to "OFF" to power off

■ Charging the Battery
. Plug the provided USB charging cable into the speaker and an active computer USB

port or a USB AC adapter that is plugged into an active wall outlet.

Charging time: 1.5hours

Remark: 1. The Bluetooth speaker can be used during charging.

2.The LED flash red when it is low battery.

■ Specifications:

Speaker: D36mm (200HZ-20KHZ)
Power output: 3W 4Ω

SNR: ≥86±3dB
Bluetooth version: 5.0

Polymer battery: 300mAh

NOTE: This equipment has been tested and found to comply with
the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are
designed to provide reasonable protection against harmful
interference in a
residential installation. This equipment generates uses and can
radiate radio
frequency energy and, if not installed and used in accordance with
the instructions,
may cause harmful interference to radio communications. However,
there is no
guarantee that interference will not occur in a particular installation.
If this
equipment does cause harmful interference to radio or television
reception, which
can be determined by turning the equipment off and on, the user is
encouraged to
try to correct the interference by one or more of the following
measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from

that to which the
receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help

Changes or modifications not expressly approved by the party
responsible for compliance

could void the user's authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is

subject to the following two conditions:

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including

interference that may
cause undesired operation.