My Music Group LC D02 User Manual

Bluetooth earphone

Charging the earphone:
Please make sure the earphone is full of charge before using it for the first time.

1. Connect the included Micro USB Charging cable to the USB Charging Port of the earphone.

2. The red indicator will turn on when charging, it will die out after full charged

Bluetooth function:

1. Press the button POWER/TEL/PP 3seconds, the Blue indicator flash, then blue and red indicator flash alternately, and it

is pairing mode.

2. Turn on the Bluetooth of your Smartphone. Search for Bluetooth device and select “ LC-D02”

3. Enter the code “0000” if needed

4. Blue indicator will light on and it is ready for use.

VOL+ /Next Song: Long press the button +
VOL-/ Pre song: Short press the button ­Play/Pause: short press POWER/TEL/PP
Power OFF: press the button POWER/TEL/PP 3seconds.

If there is no operation within 5 minutes after Power ON, it will power OFF automatically.

5. Answer/End a call: Short Press the button POWER/TEL/PP

6. Reject a Call: Double press the button POWER/TEL/PP

7. Redial the last called number: Double press the button POWER/TEL/PP

Remark: 1. the earphone will connect to your Smartphone automatically the next time when you turn it on.

Specifications:
Bluetooth version:4.2
Loudspeaker: 32ohm 5mW
Frequency response:20HZ--20KHZ
Battery capacity: 55mAh
Charging USB port
charging time: 1 hours
Play time: 1.5hours
Materials: ABS

NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help

Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.