My Music Group E22 User Manual

Bluetooth earbuds

VOL+/NEXT

Power ON/OFF
Play/Pause
Answer/End /Rejecta call

VOL-/PREV

Charging the Bluetooth Earphone:

Please make sure the earphone is full of charge before
using it for the first time.

1. Connect the included Micro USB Charging cable to the
USB Charging Port of the earphone.

2. The red indicator will turn on when charging, it will
become blue color after full charged

3. Charging time:1.5hours. Play time: 5hours

Bluetooth function:

1. Press the button 3seconds, hear voice prompt
" power on", the blue and red indicator flash alternately,
then hear another voice prompt "pairing" and it is in
pairing mode.

2. Turn on the Bluetooth of your Smartphone. Search for
Bluetooth device and select “ E22”

3. Enter the code “0000” if needed

4. After a successful connection, you will hear "connected".
Blue indicator flash and it is ready for use.

Pre /Next Song: Long press the button /
VOL-/+ : Short press the button /
Play/Pause: short press
Power OFF: press the button 5seconds.
If there is no operation within 5 minutes after Power ON,
it will power OFF automatically.
Answer/End a call: Short Press the button
Reject a Call: Long press the button
Redial the last called number: Double press the button

Remark: 1. the earphone will connect to your Smartphone
automatically the next time when you turn it on, press the
button about 2-3seconds until the Blue indicator flash.

Connecting to other Bluetooth devices:

This earphone can be connected with two Bluetooth devices
at the same time(at most).
Both connections support hands-free profile

1. First pair the earphone with Bluetooth cell phone

2. Switch off the Bluetooth device.

3. Pair and connect the earphone with another Bluetooth
device

4. Switch on the first Bluetooth device again, and it will be
automatically connected to the earphones.

Specifications:

Bluetooth version:4.2
Loudspeaker: 32ohm 5mW
Frequency response:20HZ--20KHZ
Supports Hands-free
Operating distance: about 10 meters
Battery capacity: 70mAh
Charging USB port
Charging time: 1.5 hours
Play time: 5hours
Materials: ABS

NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,

which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the followingmeasures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and
receiver.

-Connect the equipment into an outlet on a circuit different
from that to which thereceiver is connected.

-Consult the dealer or an experienced radio/TV
technician for help

Changes or modifications not expressly approved by the
party responsible for compliance could void the user's
authority to operate the equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.