My Music Group B95 User Manual

Quick Start Guide

■ Bluetooth Instruction(Note: The Bluetooth code is B95 , pair code: 0000)

1. Long press" " to power on, hear prompt sound, the blue LED light on.

2. Then you hear another prompt sound, the blue and red LED light flash
alternatively and it is in Bluetooth pairing mode. ( If there is no operation within 10
minutes, it will power off automatically.)

3. On your portable device, turn Bluetooth on, search for Bluetooth devices, and
select “B95”.

4. If you are promoted to enter a password to complete pairing, enter 0000.

5. The B95 will connect to your device and the blue LED light on.

6. It is ready for use.

7. Long press “+/-” to increase/decrease volume

Short press”+/-” to next/previous song
Short press" " to play/pause

8. Long press" " and" " synchronously to cut off Bluetooth connection.

■ Hands free function

1. Short press“ ”: Play/Pause/Answer call/End call

2. Long press" ": Refuse incoming call

3. Twice press" ": Redial the last phone number outgoing call

4. Long press“ ”: Power on/off

■ Wireless Charging function
Put your mobile phone which support wireless charging on the top charging area
It start to be charged and there show battery volume during charging

■ Charging the Battery
Before first use, please charge the Bluetooth speaker.

Plug the provided USB charging cable into the speaker and a powered USB port.
While charging, the LED light is red. Once fully charged, it will turn off.
Charging time: 5hours

Remark: 1. The Bluetooth speaker can be used during charging.

2.The LED flash red quickly and there is prompt sound when it is low battery.

■ Specifications:

Speaker: D52mm (100HZ-20KHZ)
Power output: 5W 4Ω

SNR: ≥90±3dB
Bluetooth version: 4.2
Built-in battery: 4000mAh
Play time: 10hours
Wireless Charging
Input: DC5V 1A
Output: DC5V 1A 5W

Responsible Party: LEED'S WORLD INC
Add:400 HUNT VALLEY ROAD, NEW KENSINGTON, PA 15068 USA
TEL: [phone]
Web:www.leedsworld.com

The SDoC is for the wireless charger portion. It is herewith confirmed to comply
with the requirements of FCC Part 18 Rules. Operation is subject to the following
twoconditions: (1) This device may not cause harmful interference, and (2) This
device must accept any interference received, including interference that may
cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.