MYERS LVU-2, LVU-5 Instruction Manual

LVU-2/5

INSTRUCTION MANUAL

25B9

UNIVERSAL MICRO INVERTER
PURE SINUSOIDAL AC OUTPUT
OUTPUT VOLTAGE AUTO SETTING EQUAL TO INPUT VOLTAGE
AUTO DIMMING (1-10V) OF CONNECTED LOAD

IMPORTANT SAFEGUARDS

WHEN USING E LECTRICAL EQUIPMENT, BASIC SAFETY PRECAUT IONS SHOULD ALWAYS BE FOLLOWED, INCLUDING THE FOLLOWING

READ AND FOLLOW ALL SAFETY INSTRUCTIONS

1. To prevent electric shock, switch off the mains power until installation is
complete and AC Input power is supplied to this product.

2. This product requires an unswitched AC power supply of 120-277V, 50/60Hz.

3. Make sure all connections are in accordance with the National or Canadian Electrical
code and any local regulations.

4. To reduce the risk of electrical shock, disconnect both normal power, emergency power,
unit and connector of this product before servicing.

5. For emergency operation of LED, incandescent, fluorescent, and screw-base
lamps.

6. Use this product in 0°C minimum, 50°C maximum ambient temperatures (Ta). To ensure
the emergency operating time over 90 minutes, the output emergency power of LVU-2/5
should be maximum of 25W for the LVU-2 and 50W for the LVU-5.

7. Use with grounded, UL Listed, damp location rated fixtures. Do not use outdoors. Do
not mount it near gas, heaters, air outlets or other hazardous locations.

8. Do not attempt to service the batteries. A sealed, non-maintenance battery is used that
is not field replaceable. Contact the manufacturer for information or service.

9. The use of accessory equipment not recommended by the manufacturer may cause an
unsafe condition and void warranty.

10. Do not use this product for other than intended use.

11. Installation and service should be performed by qualified service personnel.

12. This product should be mounted in locations and at heights where it will not readily be
subjected to tampering by unauthorized personnel.

THIS PRODUCT CONTAINS A RECHARGEABLE NICKEL-CADMIUM BATTERY.
THE BATTERY MUST BE RECYCLED OR DISPOSED OF PROPERLY.

Ni-cd

WW W.MYERSEP S. CO M

SAVE THIS INSTRUCTIONS

INSTALLATION

CAUTION: MAKE CERTAIN THE AC POWER IS OFF AND THE LVU-2/5 UNIT CONNECTOR IS
DISCONNECTED UNTIL THE INSTALLATION IS COMPLETE.

1. SPECIFICATION OF LVU-2/5

LVU-2 /5 SP ECIF ICAT ION

Voltage

Model

LVU-2 LVU-5

Input

120V/60Hz

277V/50Hz

Output Output Power

120V/60Hz

25W 50W

277V/60Hz

2. INSTALLING THE LVU-2/5
The LVU-2/5 can be mounted inside or outside (nearby or on top of) the luminaire.

INSIDE THE LUMINAIRE

5

2/

-

U

V

L

OUTSIDE THE LUMINAIRE

LV

U-2

/

5

LED test switch

One 7/8" (22mm) hole with conduit

LED test switch

connector for 184600.

3. INSTALLING THE LED TEST SWITCH (LTS)
Select a convenient location for the LTS so that it can be seen after installation.
Drill a 1/2"(12 mm) hole for mounting the LTS. Connect the wires from LTS to the
LVU-2/5 model according to the wiring diagram on page 3.

WW W.MYERSEP S. CO M

2/4