
™
Raijin Drive
CSP037
Designed in conjunction with Shin Suzuki, Japan’s
most celebrated amp and pedal designer, this pedal
reinvents two iconic Japanese stompboxes—an
overdrive and a distortion—with greater tonal range
and usability so that those beloved sounds can keep
up with the modern tone chase. The overdrive signal
is smooth, fat, and wide open while the distortion
signal packs an aggressive, harmonically rich punch
with just enough gain to get good and heavy.
jimdunlop.com/csp037

External Controls
3
2
1
4
1 LEVEL knob adjusts overall volume of effect
2 DRIVE SELECT switch toggles distortion/overdrive signals
3 TONE knob adjusts EQ of effect
4 DRIVE knob adjusts amount of overdrive/distortion
5 FOOTSWITCH toggles effect on/bypass (blue LED indicates on)
5
CSP037 | Raijin Drive 2

Basic Operation
Power
The Raijin™ Drive is powered by one 9-volt battery (remove
bottom plate to install), the Dunlop ECB003 9-volt adapter,
or the DC Brick™, Iso-Brick™, and Mini Iso-Brick™ power
supplies.
Directions
1 Run a cable from your guitar to the CSP037’s INPUT jack and run
another cable from the CSP037’s OUTPUT jack to your amplifier.
2 Start with all knobs set to 12 o’clock.
3 Turn the effect on by depressing the footswitch.
4 Rotate LEVEL knob clockwise to increase overall volume of effect
or counterclockwise to decrease it.
5 Rotate TONE knob clockwise for a brighter sound or
counterclockwise for a warmer sound.
6 Rotate DRIVE knob clockwise to increase amount of distortion/
overdrive or counterclockwise to decrease it.
7 Flip DRIVE SELECT switch up for distortion or down for overdrive.
CSP037 | Raijin Drive 3

Specifications
Input Impedance
Output Impedance
Max Input Level 5.1 VPP VPP
Noise Floor** Dist -100.5 dBm
Current Draw
Power Supply 9 VDC @ 7mA
** A-weighted, all controls mid position
120 kΩ @1KHz
5 kΩ @1KHz
OD -104.0 dB
7mA
CSP037 | Raijin Drive 4