TB1
Professional Audio Division
Phone: 310-333-0606 · 800-800-6608 · Fax: 310-333-0688
www.mxlmics.com · sales@mxlmics.com
Condenser Microphone
for Audio Consoles and Mixers
Thank you for choosing the MXL TB1 Gooseneck Condenser microphone.
Polar Pattern Frequency Response
With proper care, this mic will provide many years of satisfaction. To get the
best results, please take a few moments to read this manual.
Enjoy your microphone!
The MXL Team
General Characteristics
The TB1 is an electret condenser gooseneck microphone. Condenser microphones are very sensitive, readily revealing very subtle sonic details.
They also tend to pick up sounds outside the pattern more than some
designs, which can lead to powerful feedback if you are not careful. We
strongly advise experimentation with placement and isolation requirements
with the gain initially set low to avoid equipment (and ear) damage. It is
strongly advised to use the included windscreen to prevent moisture from
damaging the capsule.
Contents
Unpack your MXL TB1 microphone carefully and verify that all of the
following items are included:
Specifications
Type Electret Condenser Microphone
Maximum Sound Input Level 120dB
Polar Pattern Cardioid
Signal To Noise Ratio 75dB
Frequency Response 40 ~16000Hz
Sensitivity 10mV/Pa
Impedance 200Ω (@1KHz)
Power Requirement 48V phantom power
Polar Pattern
0
Frequency Chart
•MXL TB1
•Windscreen
If any of these items are missing or damaged, contact the company from
which you purchased the microphone.
Power Requirement
The MXL TB1 requires 48V phantom power (± 4V). If no sound is picked up
by the microphone, make sure that the phantom power on your mixer or
separate power supply is switched on.
Note: The TB1 is designed to be plugged directly into the mixer. It does not
require the use of a cable.
Care
Dust and foreign material can reduce the performance of a microphone
over time, so you should store the MXL TB1 in its box when not in use.
270
180
90
Warranty
MXL microphones are guaranteed against defects in materials and
workmanship for one year from the date of purchase. If you encounter
any problem with this unit, promptly contact the company from which
you purchased it for assistance. The original dated sales receipt will be
necessary for any warranty claim. Do not send any unit directly to us
without prior authorization from our service department. Warranty coverage
is limited to repair or replacement (at our option) of the microphone, and
does not cover incidental damages due to use of this unit, nor damage
caused by accidental misuse of this product.