MXL CR89 Users Manual

Marshall Electronics

Professional Audio Division

Phone: [phone]  800-800-6608  Fax: [phone]

www.mxlmics.com  [e-mail]

Low-Noise Condenser Microphone

Thank you for purchasing the MXL Cr89 low-noise condenser microphone.

0

With proper care, this mic will provide many years of satisfaction. For best

results, please take a few moments to review this literature.

Enjoy your microphone!

The MXL Team

General Characteristics

The MXL Cr89 is a large diaphragm condenser microphone wrapped in sharply
contrasted black and chrome. The sound is every bit as bold as the body; the
Cr89 can handle subtle acoustic guitar tones and loud vocals with the same sonic
integrity. The Cr89 has low noise circuitry and a very low proximity effect, making it
ideal for up-close recording. At home on instruments and vocals, the Cr89’s body
design minimizes body resonance while the tuned grill cavity reduces standing
waves and harmonic distortion.

Care

Dust and foreign material can degrade the performance of a microphone over
time so always store the unit in its case. For vocals closer than 3", use a pop filter
or a foam windscreen to avoid getting moisture on the diaphragm as this can
substantially degrade the microphone’s performance. Store the microphone in its
original packaging in a cool, dry place along with the included packet of silica gel.
These steps will help keep the mic in proper working order and sounding its best
for many years to come.

Specifications

Type Condenser pressure gradient mic with large 32mm capsule

Diaphragm Gold-sputtered, 6 micron diaphragm

Frequency Response 20 Hz—20kHz

Polar Pattern Cardoid

Shockmount

The high isolation shockmount may shift during shipping. Simply shift the elastic
bands to center the microphone in the assembly. Be sure that the wire clamp does
not rest on the chassis of the mount, as this impairs mechanical isolation. Slide the
shockmount up the body of the microphone and stop just below the pad switch for
the most secure hold.

Contents

Unpack your MXL Cr89 microphone carefully and verify that all of the following
items are included:

• MXL Cr89 microphone

• Shockmount

• Aluminum Flight case

• Microfiber Cleaning Cloth

If any of these items are missing or damaged, contact the company from which
you purchased the microphone.

Power Requirement

IMPORTANT - This unit requires phantom power at 48 volts, ± 4 volts.
Each unit has been thoroughly checked before shipping, so if you do not hear
sound, check that the phantom power on your mixer or separate power supply is
switched on.

Microphone Cable

This microphone connects to a mixer or preamp via XLR cable (not included). The
microphone cable can have a profound effect on the sound of any microphone.
Even the finest microphones will sound poor if the interconnect cable allows noise
to enter, or causes distortion and loss of information. Use only the best microphone
cable your budget will allow. We recommend Mogami cable for the best results.

Sensetivity -32dB re 1V/Pa

Impedance 150 ohms

Max output 1K load: + 13 dBu

Max SPL for .5% THD 138 dB SPL

S/N Ratio 80 dB (Ref. 1 Pa A-weighted)

Equivalent Noise Level 14 dB (A-weighted IEC 651)

Dynamic Range 124 dB

Power Requirements Phantom power 48V ± 4V

Weight 1.85lbs

Size 64mm x 185mm

Metal Finish Black and Black chrome

Frequency Chart Polar Pattern

+20

+10

0

-10

-20

-30
20 50 100 200 500 1K 2K 5K 10K 20K

270

180

Warranty

Marshall microphones are guaranteed against defects in material and workmanship
for one year from the date of purchase. Should you encounter any problem with
this unit, promptly contact the company you purchased it from for assistance. The
original dated sales receipt will be necessary for any warranty claim. Do not send
any unit directly to us without prior authorization from our service department.
Warranty coverage is limited to repair or replacement (at our option) of the
microphone, and does not cover incidental damages due to use of this unit, nor
damage caused by accidental misuse of this product.

90

AD092116a