MXL BCC-1 User Manual

BCC -1

1910 East Maple Ave. El Segundo, CA 90245

Phone: [phone] Fax: [phone]

Broadcast Condenser Microphone

ank you for purchasing your MXL BCC-1 Broadcast Condenser Microphone. Designed in our world class engineering facilities in
California with the professional broadcaster in mind the BCC-1 has been designed to provide you with outstanding performance and
exceptional value. e BCC-1 is an end address microphone featuring an internally shock mounted 22mm 6 micron capsule.

In addition the microphone features a switchable high pass lter (roll o) set at -6db octave at 150hz, this is useful for removing low
frequency noise from for example air conditioning units as well as providing some reduction in proximity eect if required.

Marshall Electronics, Inc.

E-mail: [e-mail]

Internet: www.MXLmics.com

Power Requirements

IMPORTANT: is microphone requires phantom power at 48volts, +/- 4 volts. Each microphone has been thoroughly checked
before shipping, so if you do not hear sound, check that phantom power on your mixer, preamp or separate power supply is switched
on .

Microphone Cables

e microphone cable can have a profound eect on the sound of any microphone. Even the nest microphones will sound poor if the
interconnect cable allows noise to enter or causes distortion and loss of information. Use only the best microphone cable your budget
will allow. We highly recommend using Mogami® brand cable.

Care

Dust and foreign material can serious degrade the performance of a microphone over time so always store the unit in a warm dry place.
To remove ngerprints from the exterior use a clean dry soft cloth.

MXL BCC-1 Specications

Type: Pressure gradient condenser mic
Diaphragm: Gold-sputtered, 6 micron diaphragm
Frequency Range: 20 Hz-20 kHz
Polar Pattern: Cardioid
Sensitivity: -49dB re 1 V/Pa
Impedance: 150 ohms
Equivalent Noise Level: -16dBA (A-weighted IEC 651)
Max SPL for 0.5% THD: 148dB SPL
High Pass Filter: 6dB/Octave @ 150Hz
Power Requirements: Phantom Power 48V ± 4V
Current Consumption: 5.2mA
Size: 200mm x 54mm / 7.87in x 2.13in (Not
including mounting bracket)
Weight: 1.6lbs / 720g
Metal Finish: Nickel Plated

Frequency Chart

Polar Pattern

0

90270

180

Warranty

Marshall microphones are guaranteed against defects in material and workmanship for three years from date of purchase. Should you
encounter any problem with this unit, promptly contact the company you purchased it from for assistance. e original dated sales
receipt will be necessary for any warranty claim. Do not send any unit directly to us without prior authorization from our service
department! Warranty coverage is limited to repair or replacement (at our option) of the microphone, and does not cover incidental
damages due to use of this unit, nor damage caused by accidental misuse of this product.