MW McWong PSC ID M FM400 User Manual

5.8Ghz Doppler Sensor User Manual

Out

Hot

Operating voltage 120-277 VAC/60HZ

Operating

Temperature

Standby consumption <0.9w Duration time MIN：5S；MAX：30M

Light control level 2LUX—2000LUX Setting height

Detection angle

WARM UP TIME About 20s,then go into auto mode after the light off

Adjustabl detection

range

-5ºC~+45ºC

wall mounting 180°

ceiling mounting360°

wall mounting: 2-12M

ceiling mounting: radius 2-7M

Maximum load

Level of IP Indoor use

Incandescent:277VAC 1200W 4.3A

120VAC 800w 6.7A

Fluorescent:277VAC 600w 2.2A

120VAC 400w 3.4A

Wall mounting 1.5-3M height

Ceiling mounting 3-4M height

CONNECTION

Neutral

DIP Switch FUNCTION

Lux

1111

On=1 Daylight 0 5-7M 0 0 5s(test) 0 0 0

Night 1 4-6M 0 1 30s 0 0 1

2-4M 1 0 1m 0 1 0

1-2M 1 1 3m 0 1 1

Off=0 5m 1 0 0

10m 1 0 1

20m 1 1 0

30m 1 1 1

sense

2222 3333

time

4444 5555 6666

5.8G microwave sensor test method

6-8M

3-4M

6-8M

6-8M

Test mode：：：：turn sensitivity knob to MAX，，，，turn time knob to MIN，，，，turn LUX knob to Sun

（（（（work at daylight））））；；；；

Steps：：：：

1．．．． Put the sensor on wall at 1.5-3M height or on ceiling 3~4M height. Black wire

connect to Hot ,white wire connect to Neutral ,Load connect between Out and

Neutral..

2. confirm 120-277VAC；；；；than power on and light on；；；；

3. The light off automatically and go into auto mode, after power on about 20s.Than

you can start test。。。。

4. When someone walk across or turn around at proper distance in front of the

sensor,no matter it is transverse or longitudinal motion,the light will turn on.When the

motion stops,the light will turn off after duration time 5 seconds.(Locate sensor testing

area away from moving objects such as flapped curtain by wind).The data as

sensitivity,detected distance/angle can be measured in this testing.If the sensitivity is

too high,it can be adjusted by DIP switch and reduce the sensitivity.The sensitivity

setting can be from 1.5 m to 7 m (radius)for ceilling mounting.
User mode：：：：select sensitivity ,time, lux you need。。。。

Steps：：：：

1. Repeat 1,2,3, steps above。。。。

2. When someone walk across or turn around at proper distance in front of the

sensor,no matter it is transverse or longitudinal motion,the light will turn on.The

light will turn off in preset time after motion stops.

3. If there is a motion during light on,the time seting will be restart as your seting.

DETECTION RANGE DRAFT

sensor

sensor

5.8Ghz microwave sensor range

Ceiling mounting

3-4M height