Muxlab Wall Mount Balun Fixture User Manual

Specifications

Environment
Application

Capacity
Compatible baluns
Orientation
Snap-in mechanism
Enclosure
Mounting holes
Mounting hardware
Dimensions
Weight
Standards
Warranty
Order Information

® Decora is a registered trademark of Leviton.

Custom audio-video systems in a structured cabling environment.
Wall or furniture recessed mounting of MuxLab baluns in audio-

video rooms, boardrooms, offices, homes, classrooms, training
centers.
Single (1) position.
MuxLab baluns measuring: 2.4” x 2.25” x 1” (6.1 x 5.7 x 2.5 cm).
Baluns may be installed front or rear facing.
Baluns lock into position via spring latch mechanism.
Black painted steel
Standard Decora® mounting hole configuration
Two (2) built-in Phillips 6-32 self-tapping screws included

1.3” (W) x 4.0” (H) x 2.7” (D) (3.3 cm x 10.3 cm x 6.8 cm)

2.6 oz (73 gms)
EIA/TIA.
Lifetime.
500910 Wall Mount Balun Fixture

8114 Trans Canada Hwy, St. Laurent, Quebec, Canada, H4S 1M5

Tel.: [phone] Fax: [phone]

Toll Free (North America): [phone]

E-mail: [e-mail] URL: www.muxlab.com

94-000630-A SE-000630-A

Wall Mount Balun Fixture (500910)

Installation Guide

Introduction

The Wall Mount Balun Fixture (500910) allows any MuxLab square balun to be
installed behind a Decora® compatible wall plate for custom AV installation. The
baluns may be installed with the RJ45 either front or rear facing depending on where
the Cat5 cabling will enter or exit the system. At the head end, the appropriate
MuxLab baluns are installed near the equipment to support a fully Cat5 cabling
solution. Each balun snaps into place and is held firmly by a spring latching
mechanism. The one-piece design makes the product easy to install and maintain.
There are no parts to lose or replace.

Installation

In order to install the Wall Mount Balun Fixture (500910), perform the following
steps:

1. Identify the final location and orientation of the Wall Mount Balun Fixture.

2. Prepare the opening in the wall or furniture using a standard single-gang or

multiple-gang low-voltage junction boxes or mud rings. The rear panel of
some junction boxes may need to be removed to provide enough depth for the
balun and cable.

3. Prepare the Cat5 wiring behind the wall and terminate with RJ45 plugs

according to the balun to be installed.

© MuxLab Inc. 2008

4. Insert the MuxLab square balun into the Wall Mount Balun Fixture by pressing

4.04" (10.26cm)

the balun against the spring clips to open them up.

Technical Drawing

The following drawings provide the basic dimensions.

5. Plug the Cat5 cable into the back of the balun and attach the completed

assembly to a mud ring or junction box using with the built-in mounting
screws.

6. Attach a Decora™ compatible wall plate (not included) over the installed

fixture using 6-32 screws.

7. The following diagram shows a typical application.

1.3" (3.3cm)

4.04" (10.26cm)

2.7" (6.8cm)

© MuxLab Inc. 2008