MuxLab 500752, 500753, 500754, 500755, 500755-AMP Quick Setup Manual

© MuxLab Inc. 2017

Luxul Ethernet Switch Quick Setup Guide

For MuxLab AV over IP Devices

Luxul Ethernet Switch Quick Setup Guide

© MuxLab Inc. 2017 2

Contents

Introduction ............................................................................................................... 3 1.

MuxLab Ethernet Switch Setup Requirements .......................................................... 3 2.

Ethernet Switch Setup ............................................................................................... 4 3.

3.1. Enabling IGMP ............................................................................................... 4

3.2. Enabling Jumbo Frames ................................................................................ 5

Preparing for System Installation .............................................................................. 6 4.

Luxul Ethernet Switch Quick Setup Guide

© MuxLab Inc. 2017 3

Introduction 1.

This document covers the basic setup requirements for a Luxul Ethernet Switch. The
setup examples and screen shots shown are for the Luxul model AMS-1208P, but these
instructions are similar and applicable to other Luxul Ethernet Switch models.

MuxLab Ethernet Switch Setup Requirements 2.

All MuxLab AV over IP Transmitters and Receivers require IGMP support to be enabled
on the Ethernet Switch, and a select number of MuxLab units also require Jumbo
Frames to be enabled.

Also note that all models below work on a 1G Ethernet Switch, except for the 500760,
which requires a 10G Ethernet Switch.

The below table specifies the IGMP and Jumbo Frames requirement per MuxLab AV
over IP Transmitter / Receiver model.

AV over IP
Model

Ethernet Switch
BW Required

IGMP
Required

Jumbo Frame
Required

500752

1G X

500753

1G X

500754

1G X

500755

1G X

500755-AMP

1G X

500756

1G X

500757

1G X

500758

1G X X

500759

1G X X

500760

10G X

500762

1G X

500770

1G X X

500771

1G X X