MUURIKKA Nokkela TO6841 Assembly Instructions Manual

Opa Muurikka Oy • Teollisuuskatu 8, 50130 Mikkeli, Finland • www.muurikka.fi

TO6841

Electric Grill / Smoking Oven 900 W

Assembly instructions / Instructions

Parts

Chip plate carriers

Closing plate

Heat resistor and fixed closing plate

Lifting handle

Lock knob

Side knob

Upper part

Legs fastening

Heating element’s input hole

Side knob fastening

Lower part

Legs Fat plate

Chip plate

Griddle

Assembly instructions

Heat resistor’s supports

Resistor support into the upper part (grilling
position)

Resistor supports into the lower part (smoking
position)

Resistor’s carrier

1

1

3

2

32

Fasten the resistor’s supports to the lower part and the upper part as shown in the picture. Two of these supports have a resistor’s carrier to make the heat
resistor lock in place. Fasten the supports that have a carrier to the side opposite to the resistor’s input hole. The longer carrier fastens to the upper part and the
shorter to the lower part. The resistor’s support with no resistor’s carrier fastens to the lower part. NOTE! The four chip plate carriers fasten to the lower part’s
resistor’s supports at the same time.

1

2

3

2

1

2

3

Fasten the legs to the ends

of the lower part with six

screws so that the check nuts enter the lower part.

Fasten the lifting handle and the side knob to the
upper part.

Fasten the lock knob by spinning it in place in the
threaded hole in the plate in the side of the upper
part. Do not turn it so much that the device will not
open.

Resistor’s carrier