muth Signal Mirror 2005 -2012 Toyota Tacoma Installation Instruction

Page 3 of 12PplPage 3 of 12

Signal®

Mirror Installation Instructions

2005 -2012 Toyota Tacoma

THE safety accessory of the 21st Century.™

P/N 210-0115-0 Rev. A3 © 2005 Muth Mirror Systems, LLC

®

INCLUDED ITEMS:

1 left and 1 right Signal® mirror
1 left and 1 right wire harness
2 wire taps
2 foam wrappers
2 housing connectors
2 ring connectors
1 instruction manual
8 cable ties (Not Required)
1 dielectric grease (Not Required)

REQUIRED TOOLS:

Ratchet with extension or ratcheting screwdriver
11mm socket
Socket wrench
T-25 Torx wrench
Large slotted screwdriver
Small slotted screwdriver
Large Phillips screwdriver
Small Phillips screwdriver
Small pry bar
Gopher rod (wire)
Electrical tape
Wire crimper and stripper
Needle nose pliers
Multimeter or wire tester
Sturdy gloves
Safety glasses or goggles
Utility knife

PROBLEMS OR QUESTIONS?

Technical Assistance is available by calling

Muth Mirror Systems Technicians at:

1-800-844-6616

Monday through Friday

Between 8:00 a.m. and 5:00 p.m. CST

Or through the Muth web site: www.muthco.com

Or via E-mail: [e-mail]

Please read instructions prior to installation.

2

PROFESSIONAL INSTALLATION RECOMMENDED

Warranty does not cover damage to the vehicle or mirror housing due to improper installation. Muth Mirror Systems, LLC (MMS)

assumes no responsibility with regard to the accuracy of this information. MMS assumes no liability or responsibility resulting from

improper installation, even in reliance upon this information. Proper installation is the responsibility of the installer. It is your

responsibility to verify any circuit before interfacing with it using a digital multimeter.

Start with opening the driver’s side door and lowering the window (A). Unsnap corner plastic triangular cover (B). Carefully remove door handle cover using a slotted
screwdriver (C). Remove screw in door handle with a Phillips screwdriver (D). With the slotted screwdriver, remove plastic covering on the grab bar (E). Release the
revealed screw using a Phillips screwdriver. Using a plastic pry bar, carefully unsnap and lift the control console (F). Disconnect all wiring connections behind control
console and remove it.

B D E

DOOR PANEL REMOVAL

A

C

F

3

K

Using a small Phillips screwdriver, push in the center post on the plastic dowel pin and release the dowel pin from the door panel (G). Carefully pry on the lower
outboard corner of the door panel using a small plastic pry bar (H). Continue prying around the door panel until it unsnaps from the door frame. Lift up and pull door
panel out a few inches away (I). Disconnect tweeter and wiring connection. Remove door panel and set it aside. Disconnect mirror harness (J). Secure the mirror
housing with one hand, remove the (3) nuts holding the mirror housing to the door frame using a 11mm socket (K). WARNING: Not securing mirror housing with
one hand before loosening the nuts could cause the mirror housing to fall and become damaged. Carefully remove mirror housing from door frame and set mirror
housing on a cloth covered surface.

H

J

DOOR PANEL & MIRROR HOUSING REMOVAL CONTINUED

G

I

4