Muskoka Sanford MEF253OK Assembly Instructions Manual
ELECTRIC FIREPLACE MANTEL Crafted in a Traditional Style
111
YEAR
ANN E
A!O
I
N
H
O
M
E
W
A
R
R
A
N
T
Y
G
A
R
A
N
T
I
E
"
L
A
M
A
I
S
O
N
G
A
R
A
N
T
#
A
E
N
S
U
P
R
O
P
I
A
C
A
S
A
MANTEAU DE CHEMINÉE ÉLECTRIQUE Confectionné en style traditionnel
REPISA DE CHIMENEA ELÉCTRICA Fabricado con diseño tradicional
MM253OK
Assembly Instructions
Instructions d'assemblage
Instrucciones de montaje
REV01
TIPS FOR THE ASSEMBLY OF
YOUR NEW MANTEL
• Before you begin assembly, locate the instructions and hardware. Take out all the parts and
compare them to the diagrams below. Be sure you have all the parts and can identify them.
• A helping hand is always good. Assemble your mantel with an adult assistant if possible. Some
pieces are heavy and will need to be held by a helper. Assembly time will take approximately
30-60 minutes.
BASE 1PC
ZZ.253OK.01
TOP 1PC
ZZ.253OK.02
UPPER FACING
PANEL 1PC
ZZ.253OK.07
INSIDE
LEFT FRONT
PANEL 1PC
ZZ.253OK.03
VIEW
LEFT SIDE PANEL
ZZ.253OK.04
1PC
OUTSIDE
VIEW
RIGHT FRONT
PANEL 1PC
ZZ.253OK.05
CENTRAL PANEL
1PC
ZZ.253OK.08
RIGHTSIDE
PANEL 1PC
ZZ.253OK.06
29PCS 4PCS
2PCS 2PCS 4PCS 4PCS
ANTI-TIP DEVICE 2 SETSFLAT HEAD SCREWS
4PCS
1
GET READY TO START
Before assembly, use scissors to unwrap the parts from the packaging. DO NOT use a box cutter or
exacto-knife as you may cut into the mantel pieces inside the box and damage the finish. Check for the
hardware bag which is
NOT discard any pieces. Use an appropriate screwdriver to insert and tighten all screws.
Step 1
Locate the base and place it on the floor. DO NOT put it up against
the wall at this point in the assembly, as you need to get in behind
the mantel to insert several wingnuts, lock washers and firebox screws.
Step 2
Locate the left side panel and the left front panel. Facing the
front of the base, take the left side panel, positioning it so the holes
in the blocks on the bottom line up with the holes on the base. Position the left
front panel next to the left side panel, lining up the holes in the blocks with the
holes on the base. Attach the left front and side panel to the base by inserting
and tightening 1 screw to each piece. Attach the left side and left front panels
together by inserting and tightening
3 screws.
RED and located inside the packaging, taped to the top box. Be sure you DO
Step 3
Repeat Step 2, but with the right side panel and the right front panel.
2
Loading...