Muskoka Manitou MM255CH Assembly Instructions Manual
ELECTRIC FIREPLACE MANTEL with Corner Option
111
YEAR
ANN E
A!O
I
N
H
O
M
E
W
A
R
R
A
N
T
Y
G
A
R
A
N
T
I
E
"
L
A
M
A
I
S
O
N
G
A
R
A
N
T
#
A
E
N
S
U
P
R
O
P
I
A
C
A
S
A
MANTEAU DE CHEMINÉE ÉLECTRIQUE avec coin facultatif
REPISA DE CHIMENEA ELÉCTRICA con opción para poner en rincon
MM255CH
Assembly Instructions
Instructions d'assemblage
Instrucciones de montaje
REV00
TIPS FOR THE ASSEMBLY OF
YOUR NEW MANTEL
• Before you begin assembly, locate the instructions and hardware. Take out all the parts and
compare them to the diagrams below. Be sure you have all the parts and can identify them.
• A helping hand is always good. Assemble your mantel with an adult assistant if possible. Some
pieces are heavy and will need to be held by a helper. Assembly time will take approximately
30-60 minutes.
BASE 1PC
ZZ.255CH.01
TOP 1PC
ZZ.255CH.02
UPPER FACING
PANEL 1PC
ZZ.255CH.07
INSIDE
VIEW
LEFT FRONT
PANEL 1PC
ZZ.255CH.03
LEFT SIDE PANEL
1PC
ZZ.255CH.04
CORNER ATTACHMENT 1PC
ZZ.255CH.08
RIGHT FRONT
PANEL 1PC
ZZ.255CH.05
OUTSIDE
VIEW
RIGHTSIDE
PANEL 1PC
ZZ.255CH.06
28PCS 4PCS
2PCS 2PCS 4PCS 4PCS 4PCS
ANTI-TIP DEVICE 2 SETSFLAT HEAD SCREWS
1
GET READY TO START
Before assembly, use scissors to unwrap the parts from the packaging. DO NOT use a box cutter or
exacto-knife as you may cut into the mantel pieces inside the box and damage the finish. Check for the
hardware bag which is
NOT discard any pieces. Use an appropriate screwdriver to insert and tighten all screws.
Step 1
Locate the base and place it on the floor. DO NOT put it up against
the wall at this point in the assembly, as you need to get in behind
the mantel to insert several screws.
Step 2
Locate the left side panel and the left front panel. Facing the front of the base,
take the left side panel, positioning it so the holes in the blocks on the bottom line
up with the holes on the base. Position the left front panel next to the left side
panel, lining up the holes in the blocks with the holes on the base. Attach the left
front and side panel to the base by inserting and tightening 1 screw to each piece.
Attach the left side and left front panels together by inserting and tightening
3 screws.
RED and located inside the packaging, taped to the top box. Be sure you DO
Step 3
Repeat Step 2, but with the right side panel and the right front panel.
2
Loading...