MUSIC Tribe PH DW20T User Manual
AIR LINK DW 20R/DW 20T
2.4 GHz Wireless Stereo Receiver/Transmitter for High-Performance
Stereo Audio Broadcasting
(8) (9)
(1) (2) (4)(3)
(5)
(1) (6) (4)(7)
(1) PAIR button enable s the unit to become available for
pairing by pressing and holding for 4 seconds. The LED ring
will indicate the current status.
See the Get ting Started section for details.
(2) LEVEL knob adjusts the volume of the signal sent to the
output jacks.
(3) SIGNAL LEDs light when the DW 20R receives an audio
signal from the DW 20T.
(4) DC INPUT socket accepts the included power adapter.
(5) STEREO/MONO switch determines whether the outgoing
wireless audio signal is stereo or mono.
(6) LEVEL knob adjusts the sensitivit y of the inputs.
(7) SIGNAL LEDs light green when signal is pre sent at the
inputs. The LEDs light red when the incoming audio signal
clips the inputs.
If this happens, lower the output level of the source audio.
(8) OUTPUT jac ks send a line-level audio signal to another
audio device (mixer, amplier, etc.) via balanced XLR or
unbalanced ¼" TS cables.
(9) INPUT jacks accept audio signals via b alanced XLR or
unbalanced ¼" TS cables.
Getting Started
1. Connect the DW 20T inputs to an or iginal audio source such as a mixer or media player, then connect the outputs of t he DW 20R to a destination such as a mi xer, amplier,
or active speaker. Leave the amp or speaker s turned o for now.
2. Connect the power adapter s to each unit. They will power on automatically and their PAIR buttons will blink slowly to indicate s tandby mode.
3. Press and hold the PAIR button on the DW 20T for 4 seconds. The LED ring will ash rapidly to indicate that it is trying to pair, and will cont inue trying for up to 30 seconds.
4. Within 30 seconds of initiating the DW 20T for pairing, press and hold the PAIR button on the DW 20R for 4 seconds as well. Its LED ring will ash rapidly.
5. When successfully paired, the LED rings on both the 20T and 20R will light solid (not ashing). If either unit ’s LED ring ashes slowly, this indicates that pairing was unsuccessful.
Make sure both uni ts are free of obstructions and are within 100 f eet / 30 meters of each other.
6. After all audio and power connections have been made, power on the amplier or active speakers.
Pairing multiple DW 20R units with a DW 20T
1. Connect the DW 20T and the rst DW 20R as described in ‘Get ting Started’ (hold each PAIR button for 4 seconds).
2. On the second DW 20R unit, hold the PAIR button for 4 seconds to ac tivate pairing, then let it search for 30 seconds. The pairing func tion will time out af ter 30 seconds and the LED
will blink slowly.
3. Press the DW 20T PAIR but ton for 4 seconds, and then press the second DW 20R unit ’s PAIR button for 4 seconds. Both DW 20R units will now be connec ted to the same DW 20T.
4. Note - holding the PAIR button for 10 seconds on the DW 20T will clear the memor y of connected DW 20R unit s.
Specications
DW 20R DW 20T
Inputs
Connector s —
Impedance —
Max. input level — 10 dBu
Outputs
Connector s
Impedance 240 Ω —
Max. output level 15 dB u —
Wireless
Channels
Bandwidth >1. 8 M Hz
Transmission frequency
Wireless range Up to 30 m (100 ft)
Sensitivity -81 dBm @ 1% PER —
Transmission power —
System
Frequency response 20 Hz to 20 kHz (±1 dB)
THD + N (distor tion) 0.1% @ 1 kHz
Signal-to-noise ratio >90 dB
Power adaptor 12 V DC, 400 mA, ce nter positive
Physical
Dimensions (H x W x D)
Without bumpers or antenna 54 x 108 x 103 mm (2.1 x 4.3 x 4.1")
With bumpers, without antenna 63 x 118 x 112 mm (2.5 x 4.6 x 4.4")
With bumpers, upright antenna 212 x 118 x 126 mm (8.3 x 4.6 x 5.0")
Weight (incl. bumpers and antenna) 0.6 kg (1.3 lbs)
Balanced XLR,
unbalanced ¼"
2.406 – 2.475 GHz
Balanced XLR,
unbalanced ¼"
10 kΩ balance d,
15 kΩ unbalanced
—
24
12 dBm
LEGAL DISCLAIMER
MUSIC Tribe accepts no liability for any loss which may be suered by any person
who relies either wholly or in part upon any description, photograph, or statement
contained herein. Technical specications, appearances and other information are
subject to change without notice. All trademarks are the property of their respective
owners. MIDAS, KLARK TEKNIK, LAB GRUPPEN, LAKE, TANNOY, TURBOSOUND,
TC ELECTRONIC, TC HELICON, BEHRINGER, BUGERA and COOLAUDIO are trademarks or
registered trademarks of MUSIC Tribe Global Brands Ltd. © MUSIC Tribe Global Brands
Ltd. 2018 All rights reserved.
LIMITED WARRANTY
For the applicable warranty terms and conditions and additional information regarding
MUSIC Tribe’s Limited Warranty, please see complete details online at musictri.be/warranty.
Antenna information
The Wireless Systems has been designed to pass certification with the
antenna listed below. The required antenna impedance is 50 ohms. The
used two antennas are equivalent antenna (same size, same yagi, same
dish, size maximum gain: 5.0 dBi, same type: dipole), only difference
brand/model.
End-user cannot change antenna.
Responsible Party Name: MUSIC Tribe Commercial NV Inc.
Address: 5270 Procyon Street
Las Vegas, NV 89118
USA
Phone Number: +1 702 800 8290
AIR LINK DW 20R/DW 20T
complies with the FCC rules as mentioned in the following paragraph:
This equipment has b een tested and found to comply with the limits for a Class B
digital device, pur suant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and us ed in accordance with the instruc tions, may cause harmful inter ference
to radio communications. However, there is no guarantee that interference will not
occur in a par ticular installation. If this equip ment does cause harmful inter ference to
radio or television reception, which can be determined by turning the equipment o
and on, the user is encouraged to try to correc t the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with Par t 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any inter ference received, including inter ference that may
cause undesired operation.
FCC ID: QWHDW20T
This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
Caution!
The MUSIC Tribe is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment.
Such modif ications could void the user authorit y to operate the equipment
FCC RF Radiation Exposure Statement:
(1) This Transmit ter must not be co-located or operating in conjunction with any
other antenna or transmitter.
(2) This equipment complies with FCC RF radiation exposure limits set forth for
an uncontrolled environment. This equipment should be installed and operated
with a minimum distance of 20 centimeters between the radiator and your body.
Loading...