MUSIC Tribe PH DW20BR User Manual

AIR LINK DW 20BR

Controls

(1) (2) (3) (4)

(1) PAIR button – enables the unit to become available for pairing by pressing and

holding the button for 3 seconds. The LED ring will indicate the current status.
See the Get ting Started section for details.

(2) LEVEL knob – adjusts the volume of the signal sent to the out put jacks.

(3) DC INPUT – accepts the included power adapter.

(4) OUTPUTS – connect to an amp, powered speakers, or mixer via balanced XLR or

unbalanced ¼" TS cables.

Getting Started

1. Connect the DW 20BR to a mixer or speaker system with either XLR
or ¼" cables. Keep the volume on the speaker or mixer channel turned all
the way down to avoid popping noises.

2. Connect the power adapter to the DW 20BR and to a power outlet. The unit
will turn on automatically.

3. Activate Bluetooth connectivity on your Bluetooth device. The DW 20BR will
automatically try pair with the most recently connected device, in which case
you can start playing audio right away.

4. To connect a new device, press and hold the PAIR button for 3 seconds.
The LED ring will  ash quickly to indicate that it is ready to pair.

5. Select the DW 20BR from the list of available items in the Bluetooth settings
menu of your Bluetooth device.

Note - disable cellular reception when streaming audio from a cell phone.

6. Start playing audio from your Bluetooth device. Adjust the volume on the
Bluetooth device, then turn up the LEVEL knob so that the speaker or mixer
receives a strong signal.

7. Turn up the volume on your speaker, mixer, amps, etc. until you reach the
desired listening level.

Note - If your Bluetooth audio device is compatible, Play/Pause can be toggled
with a short press of the PAIR button on the DW 20BR while the bluetooth
stream is active.

Speci cations

FEDERAL COMMUNICATIONS
COMMISSION COMPLIANCE

Outputs

Connectors Balanced XLR, unbalanced ¼ "

Impedance 240 Ω

Max. outpu t level 4 dBu @ 1 kHz

Bluetooth

Frequency range 2402 - 2480 MHz

Channel number 79

Bluetooth ver sion 4.2

Receiver range Up to 30 m (100 ft)

Output power Class 2, <10 dBm

Supported codec SBC, aptX

Supported pro le s AVRCP 1.4, A2DP 1.2

System

Frequency response 20 Hz to 20 kHz (+0/-2 dB)

THD + N (distortion) 0.1% @ 1 kHz

Signal-to-noise ratio >90 dB

Power adaptor 12 V DC, 400 mA, center positive

Physical

Dimensions (H x W x D)

Without bumpers or antenna 54 x 105 x 105 mm (2.1 x 4.1 x 4.1")

With bumper s, without antenna 62 x 116 x 112 mm (2.4 x 4.6 x 4.4")

With bumper s, upright antenna 210 x 116 x 125 mm (8.3 x 4.6 x 4.9")

Weight incl. bumper s and antenna 0.6 kg (1.3 lbs)

INFORMATION

KLARK TEKNIK

AIR LINK DW 20BR

Responsible Par ty Name: MUSIC Group Research

UK Limited

Address: Klark Industrial Park,

Walter Nash Road,
Kidderminster. Worcestershire.
DY11 7HJ. England.

Phone Number: [phone]

AIR LINK DW 20BR

complies with the FCC rules as mentioned in the following paragraph:

This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful inter ference when the equipment is operated
in a commercial environment. This equipment generates, uses, and can radiate radio
frequenc y energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to c ause harmful interference in which case the
user will be required to correc t the interference at his own expense.

Caution!

Note: The ¼ " o utput level is 6 dB lower than t he XLR outputs

The MUSIC Group is not re sponsible for any radio or TV inter ference caused by
unauthorized modi cations to this equipment. Such modi cations could void the user
authority to operate the equipment.

FCC RF Radiation Exposure Statement:

(1) This Transmit ter must not be co-located or operated in conjunc tion with any other
antenna or transmitter.

(2) This equipment complie s with FCC RF radiation exposure limits set for th for an
uncontrolled environment. This equipment should be installed and operated with a
minimum distance of 20 centimeter s between the radiator and your body.

Important information:

Changes or modi cations to the equipment not expressly approved by MUSIC Group can
void the user’s authority to use the equipment.

LEGAL DISCLAIMER

MUSIC Group accepts no liability for any loss which may be su ered by any person who relies either wholly or in part upon any description, photograph, or statement contained herein.
Technical speci cations, appearances and other information are subject to change without notice. All trademarks are the property of their respective owners. Midas, Klark Teknik,
Lab Gruppen, Lake, Tannoy, Turbosound, TC Electronic, TC Helicon, Behringer, Bugera, COOLAUDIO and EUROCOM are trademarks or registered trademarks of MUSIC Group IP Ltd.
© MUSIC Group IP Ltd. 2017 All rights reserved.

LIMITED WARRANTY

For the applicable warranty terms and conditions and additional information regarding MUSIC Group’s Limited Warranty, please see complete details online at music-group.com/warranty.