Musicom Lab EFX LIRE6V, EFX LITE 6M User Manual

USER MANUAL

( Rev 1.0 )

EFX LITE 6M Audio Controller User Manual 2

1. Introduction

The EFX LITE 6M Audio Controller is the ultimate floor-based switching system.

It is a compact, easy to use, has 6 fully programmable loops and a MIDI foot controller.

The EFX LITE 6M Audio Controller has 60 memory locations, configured as 15 banks of 4 presets, plus a

global preset. It can transmit 2 MIDI Program Change messages on 2 MIDI channels and 8 MIDI Control

Change messages on an appointed MIDI channel.

The EFX LITE 6M Audio Controller has a low-noise, high quality buffer to prevent the loss of guitar signal.

The EFX LITE 6M Audio Controller is made of high quality parts, including heavy-duty stomp switches and

gold-plated relays.

It is cased within a compact and rugged aluminium enclosure.

2. Basic Connection

TUNER

FX1

FX2 FX4

FX3 FX5 FX6

CHORUS

DELAY

AMP

Volume

Pedal

EFX LITE 6M Audio Controller User Manual 3

3. Mode Description

The EFX LITE 6M Audio Controller utilizes two modes of operation: Preset Mode and Instant Access Mode. On

power-up, the display will show its firmware version, upon which bank 1 and the global preset will be

selected.

3.1 PRESET MODE

The EFX LITE 6M Audio Controller has 60 presets, configured as 15 banks of 4 presets, plus a global preset

which is common to all banks. (Bank : 1, 2, 3, ... , 9, A, B, C, D, E, F)

The Preset Mode is automatically selected when the power is initially turned on.

ྙG Press & hold the MODE switch for 1 second. The LEDs above the P2 and P3 switches will flash.

ྚG Press the P2(BANK DOWN) or P3(BANK UP) switches to scroll through the 15 available banks. The display

will flash.

ྛG Press the MODE switch. The LEDs above the P2 and P3 switches will stop flashing.

ྜG The preset is selected via pressing any switches from P1 through P4. The display will stop flashing and

the LED above the switch turns on.

NOTE : If you want to select P1, skip the procedure ྛ~ྜGand press the P1 switch.

The global preset is a preset with all the capabilities of preset 1 through 4, but is the same for all banks.

Pressing the switch of a preset that is already on selects the global preset and will cause the LED above the

switch to turn off.

MUTE

Press & hold the switch of a preset that is already on, for 1 second. The decimal point on the display will

turn on and the audio signal will be muted.

To mute the audio signal, the audio line must be connected to the MUTE IN and MUTE OUT jacks.

Press the any preset switch to cancel the mute function. The mute function is not available on the global

preset.

3.2 INSTANT ACCESS MODE (Programming the Loops)

ྙG Select the preset to be programmed in the Preset Mode.

ྚG Press the MODE switch to enter the Instant Access Mode. The display will show ' - '.

And the 4 LEDs above the P1 ~ P4 switches will indicate the corresponding Loop1 ~ Loop4 as on or off.

ྛG Press the P1 through P4 switches to turn the corresponding Loop1 ~ Loop4 on or off. The corresponding

LEDs will go on or off and the decimal point on the display will flash.