Music Hall Cruise Control 2.0 User Manual

music hall

cruise control 2.0

INSTRUCTION MANUAL

music hall

http://www.musichallaudio.com

CONGRATULATIONS ON YOUR PURCHASE

You have selected an exceptional electronic speed control. Each component used
in the construction of the cruise control 2.0 was selected to provide you with
superior performance and the highest level of sound reproduction available today.
We know of no electronic speed control that costs as much to produce yet sells for
so little. The precise and elegant design of this electronic speed control makes it
easy to install and operate. Please take a few moments to read over the
operating instructions to ensure that you get the best performance from your
speed control and years of trouble-free service.

SAFETY GUIDELINES

This product is designed and manufactured to strict quality and safety standards.
However, you should be aware of the following installation and operation
precautions:

1. Take heed of warnings and instructions

Read all the instructions before connecting or operating the speed control.

Keep this manual so you can refer to these safety instructions.

2. Water and Moisture

To reduce the risk of fire or electric shock, do not expose the electronic speed
control to moisture or water. If the speed control is exposed to moisture,
immediately disconnect the power cord from the wall. Take the speed control to
an authorized music hall service center for inspection. Do not touch the speed
control, power cord, or plug with wet hands.

3. Object or liquid entry

Do not allow foreign objects or liquids into the unit. If this happens, immediately
disconnect the power cord from the wall and take the unit to an authorized music
hall service center for inspection.

4. Heat

Keep the electronic speed control away from naked flames, radiators, heat
registers, stoves, or any other heat-producing appliances (including amplifiers).

1

5. Climate

The electronic speed control has been designed for use in moderate climates. Do
not attempt to use below 41 degrees Fahrenheit (5 degrees Celsius) or above 95
degrees Fahrenheit (35 degrees Celsius).

6. Racks and Stands

Place the electronic speed control on a fixed, level surface strong enough to
support its weight. Do not place it on a moveable cart that could tip over. We
recommend only using stands approved for use with audio equipment.

7. Cleaning

A soft towel can be used.

8. Power Sources

Connect the electronic speed control to a power supply of the type and voltage
described in the operating instructions or specified on the rear panel of the unit.

9. Power-cord protection

Connect the electronic speed control to the power outlet only with the supplied
power supply. Do not modify the supplied power supply in any way. Do not
attempt to defeat grounding and/or polarization provisions.

Do not use extension cords.

Do not route the power cord where it will be crushed, pinched, bent at severe
angles, exposed to heat, or damaged in any way.

10. Non-use periods

If the speed control is to be left unused for a long period of time, the power
supply should be unplugged from the wall outlet.

11. Damage Requiring Service

Stop using the electronic speed control immediately and have it inspected by an
authorized Music Hall service center whenever:

1. The power supply cord or plug has been damaged.

2. The electronic speed control has been exposed to rain.

3. The speed control does not operate properly.

4. The speed control has been dropped or damaged.

5. Smoke or any unusual smell is detected from the electronic speed control.

2