
X-PSU
V8
X-V8 SERIES POWER SUPPLY UNIT
INSTRUCTIONS FOR USE
Thank you for purchasing the Musical Fidelity X-PSU V8.
The X-PSU V8 is a high quality power supply unit designed to complement the X-
V8
series components. It will
conveniently drive up to four X-
V8
series components from a single mains point with no compromise in
performance.
Dust regularly with a soft duster or soft brush, but be careful when using cleaning or polishing agents - they
may harm the surface finish.
If you have any questions about your audio system,
Please consult your dealer who is there to help and advise.

X-PSU
V8
CONTENTS
Issue 1
Page 2 of 10
PAGE
3 Safety information
- Safety information
4 General advice
- - Installation precautions
User information
5 Item disposal information
- EU disposal information
6 Installation
-
-
-
-
Introduction
Installation
Connections
Cleaning
7 Facilities and connection
- Illustrations - front and rear panels
8 Power supply problems?
- Basic fault finding
9 Power supply specifications
10 Manual history

X-PSU
V8
SAFETY INFORMATION
Issue 1
Page 3 of 10
IMPORTANT! (U.K. only)
This unit is supplied in the U.K. with mains lead fitted with a moulded 13 amp plug. If, for any reason, you need to cut
off the plug, please remove the fuse holder and dispose of the plug safely, out of reach of children.
It must not be
plugged into a mains outlet.
The wires in the mains lead supplied with this appliance are coloured in accordance with the following code:
Green and yellow..............Earth
Blue................................Neutral
Brown.................................Live
WARNING - This appliance MUST be earthed
As the colours of the wires of the mains lead of this appliance may not correspond with the
coloured markings identifying the terminals in your plug, proceed as follows:
The wire which is coloured green-and-yellow must be connected to the terminal in the plug which is marked with the
letter E or coloured green or green-and-yellow, or by the earth symbol :
The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red.
The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black.
If connecting to a BS1363 plug, a 13 amp fuse must be used.
WARNING:
ANY MODIFICATIONS TO THIS PRODUCT NOT EXPRESSLY APPROVED
BY MUSICAL FIDELITY WHO IS THE PARTY RESPONSIBLE FOR
STANDARDS COMPLIANCE COULD VOID THE USER'S AUTHORITY TO
OPERATE THIS EQUIPMENT.