Musical Fidelity XP-100 Owners manual
REMOTE CONTROL CLASS A
PREAMPLIFIER
INSTRUCTIONS FOR USE
Thank you for purchasing the Musical Fidelity
X-P100 Remote Control Class A Pre-Amplifier.
Used properly and carefully, it should give you many
years of outstanding musical reproduction.
This X-P100 is closely based on our highly
regarded (and now unavailable) Nu-Vista model but
uses a specially selected J-FET in place of the
Nuvistor triode.
The X-P100 has been designed to offer almost
indistiguishable sonic charateristics to the Nu-Vista.
Aesthetically and electronically the X-P100 matches
perfectly with the X-AS100 power amplifier, X-RAY 24 bit
CD player and X-PLORA tuner. Together, they form one
of the finest hi-fi systems available.
Dust regularly with a soft duster or soft brush but be
careful when using cleaning or polishing agents - they may
harm the surface finish.
If you have any questions about anything in your
audio system, please consult your dealer who is there
to help and advise you.
X-P100
Instructions For Use. Page 1
PLEASE READ
IMPORTANT!
This unit is supplied in the UK with a mains lead fitted with a moulded 13 amp plug.
If, for any reason, you need to cut off this plug, please observe the following safety precautions. Please dispose of the cut-off plug safely. It must not be plugged into a mains power
supply.
The wires in the mains lead supplied with this appliance are coloured in ac-
cordance with the following code:
Green and yellow..............Earth
Blue...............................Neutral
Brown................................Live
WARNING - This appliance must be earthed
As the colours of the wires of the mains lead of this appliance may not correspond
with the coloured markings identifying the terminals in your plug, proceed as follows:
• The wire which is coloured green-and-yellow must be connected to the terminal in the plug which is marked with the letter E or coloured green or green-and-yellow, or
by the earth symbol .
•The wire which is coloured brown must be connected to the terminal which is
marked with the letter L or coloured red.
•The wire which is coloured blue must be connected to the terminal which is
marked with the letter N or coloured black.
•If connecting to a BS1363 plug, a 10 amp fuse must be used.
WARNING - Radio Frequency Interference (RFI)
This hi-fi product has been tested to ensure that its operation will not be adversely
affected by normal background levels of RFI. It is possible that if this product is subjected
to abnormally high levels of RFI the unit may be susceptible and not perform as expected.
In the unlikely event of this happening on a regular basis, please contact Musical Fidelity's
service department.
The unit has also been tested to ensure that it does not radiate excessive levels
of RFI that could affect other pieces of electronic or electrical equipment.
The electronics in modern hi-fi equipment is complex and hence may be damaged by lightning. It is possible that during electrical storms the operation of some
equipment may be adversely affected. For complete protection of your hi-fi system
during such storms, mains plugs and aerial leads should be disconnected.
Always ensure that when disconnecting and reconnecting your hi-fi equipment the mains
supply is switched off.
X-P100
Instructions For Use. Page 2
CONNECTIONS AND FACILITIES
1
2 3 4 5
FRONT VIEW
1 Main unit power on indicator LED
2 Volume control
3 Infra Red remote receiver lens
4 Tape monitor button
5 Source selector switch
6 7 8 9 10 11 12 13 14 15
BACK VIEW
6 Input from external PSU unit
7 Tape record output
8 Tape input
9 Aux 2 input
10 Aux 1 input
11 Tuner input
12 CD input
13 Preamp Output
14 Phono (MM) input
15 Phono chassis earth
X-P100
Instructions For Use. Page 3
Loading...