Musical Fidelity A1001 User Manual
A1001 CLASS A SUPER
INTEGRATED AMPLIFIER
INSTRUCTIONS FOR USE
Thank you for purchasing the Musical Fidelity
A1001 Class A Super Integrated Amplifier. Used
properly and carefully, it should give you many
years of outstanding musical reproduction.
The A1001 has been designed for the very high-
est possible sound quality allied to a natural tonal-
ity that brings life and soul to all forms of music.
We have invested much time and effort in the design
of this unit, we sincerely hope you will be delighted
with your purchase.
Dust regularly with a soft duster or soft brush
but be careful when using cleaning or polishing
agents - they may harm the surface finish.
If you have any questions about anything in
your audio system, please consult your dealer who
is there to help and advise you.
Instructions For Use. Page 1A1001
PLEASE READ
IMPORTANT!
This unit is supplied in the UK with a mains lead fitted with a moulded 13 amp
plug. If, for any reason, you need to cut off this plug, please observe the following
safety precautions. Please dispose of the cut-off plug safely. It must not be plugged
into a mains power supply.
The wires in the mains lead supplied with this appliance are coloured in ac-
cordance with the following code:
Green and yellow..............Earth
Blue...............................Neutral
Brown................................Live
WARNING - This appliance must be earthed
As the colours of the wires of the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as
follows:
•The wire which is coloured green-and-yellow must be connected to the termi-
nal in the plug which is marked with the letter E or coloured green or green-andyellow, or by the earth symbol .
•The wire which is coloured brown must be connected to the terminal which is
marked with the letter L or coloured red.
•The wire which is coloured blue must be connected to the terminal which is
marked with the letter N or coloured black.
•If connecting to a BS1363 plug, a 10 amp fuse must be used.
WARNING - Speaker Terminals
In order to comply with BSEN60-065 safety regulations, the 4mm. banana plug
holes have been fitted with plastic blanking pieces. Removal of these will invalidate
any safety approval of this unit.
WARNING - Radio Frequency Interference (RFI)
This hi-fi product has been tested to ensure that its operation will not be adversely affected by normal background levels of RFI. It is possible that if this product is subjected to abnormally high levels of RFI the unit may be susceptible and not
perform as expected. In the unlikely event of this happening on a regular basis,
please contact Musical Fidelity's service department.
The unit has also been tested to ensure that it does not radiate excessive levels
of RFI that could affect other pieces of electronic or electrical equipment.
The electronics in modern hi-fi equipment is complex and hence may be damaged by lightning. It is possible that during electrical storms the operation of some
equipment may be adversely affected. For complete protection of your hi-fi system
during such storms, mains plugs should be removed and aerial leads disconnected.
Always ensure that when disconnecting and reconnecting your hi-fi equipment
the mains supply is switched off.
Instructions For Use. Page 2A1001
CONNECTIONS AND FACILITIES
3
1 2 4 5 6
FRONT PANEL
1 Power (on / off) button
2 Tape / source select (tape
monitor) button
3 Volume control
4 Volume position & mute LED
5 Source selector buttons
6 Remote receiver lens
7 8 9 10 11 12 13 14 15 16
BACK PANEL
7 Right speaker outputs
8 CD input
9 Tuner input
10 Aux 1 input
11 Aux 2 input
12 Aux 3 input
13 Tape input
14 Tape record output
15 Preamp output
16 Left speaker outputs
17 Right preamp & power amp link
18 Left preamp & power amp link
19 IEC type mains inlet
17 18 19
Instructions For Use. Page 3A1001
Loading...