Murphy PVS-5 User Manual

PVS-5 Power Supply – Installation Instructions

• Provides 5 Volt power supply to PVM gages

• Capable of supplying power to a maximum of 6 PVM gages

• Enables PVM gage compatibility with existing MurphyLink products

• Easy mounting and installation

External power is required to make the PVM gage line compatible with existing
MurphyLink products, i.e. PV1000, Cascade, iGUARD and eGUARD. The PVS-5
power supply device supplies 5 Volts of external power and load dump
protection for up to 6 PVM gages. The maximum length of the power and data
connection between gages is 0.5meters (8.5 meters total).

The unit may be installed inside a panel or behind a dash.

Product Dimensions

00-02-0645

01-21-09

Section 78

Specifications

Input Voltage:

• 6 VDC minimum to 32 VDC maximum

• 12/24 VDC Nominal

Output Voltage: 5 VDC @ 450mA maximum
Reverse Polarity Protection: -36VDC
Overvoltage Protection: +36VDC and above
Overcurrent Protection: 600mA @ 36VDA

maximum
Connector: AMP 1-770968-1

In order to consistently bring you the highest quality, full featured products, we reserve the right to change our specifications and designs at any time.
MURPHY, the Murphy logo, MurphyLink
including textual matter and illustrations, is copyright protected by Murphy Industries, Inc., with all rights reserved. (c) 2008 Murphy Industries, Inc.

™

and PowerView™ are registered and/or common law trademarks of Murphy Industries, Inc. This document,

Operating Temperature: -40°F to 185°F (-40°C to +85°C)
Storage Temperature: -40°F to 221°F (40°C to +105°C)
Random Vibration: 5-2,000 Hz
Operating Shock: 50G
Certification: CE
Case Material: Polyamide
Dimensions: 2”x2”x.75”
Mounting Hole Dimensions: Two #8 screws,

1.625" offset

Mounting

The PVS-5 can be mounted under or behind the dash using cable ties or screws. Refer to the following installation
examples when mounting the power supply device.

CAUTION: The mating connector does not
have a water tight seal. If the device is
mounted in a location exposed to the risk of
moisture, then the device should be mounted
in an orientation that will protect the
connector from water seepage (connector
facing down) or sealed against moisture.

Mounted using two #8 screws

Mounted using cable ties through

each of the mounting holes.

Mounted using one cable tie

across the device.

Wiring Diagram

The pin out information for the 4 pin connector is shown below.

Mating Connector

– Tyco Electronics AMP Mini
Universal Mate-N-Lok Plug Housing 4 Position,
AMP P/N 172338-1
Murphy P/N 00-00-6935

Accessories

Model Wiring harness Rendering Wiring Harness Designation Schematic Part Number

PVWM-J

PVM Gage Harness

78-00-0479
78-00-0490
78-00-0503

Warranty

may be viewed or printed by going to www.fwmurphy.com/support/warranty.htm

- A limited warranty on materials and workmanship is given with this FW Murphy product. A copy of the warranty