Murphy PV-101 User Manual

PowerView™

Model PV -101

User’s Guide

Rev 09-10-08 00-02-0605
Catalog Section 78

In order to consistently bring you the highest quality, full
featured products, we reserve the right to change our
specifications and designs at any time. The latest version of
this manual can be found at www.fwmurphy.com.

Warranty - A limited warranty on materials and

workmanship is given with this FW Murphy product. A copy
of the warranty may be viewed or printed by going to
www.fwmurphy.com/support/warranty.htm

BEFORE BEGINNING INSTALLATION OF THIS
MURPHY PRODUCT:

• Disconnect all electrical power to the machine.

• Make sure the machine cannot operate during

installation.

• Follow all safety warnings of the machine
manufacturer.

• Read and follow all installation instructions.

T able of Content s

Introduction ............................................................................. 1

Engine and Transmission Parameters 2
Faceplate Features 3
Navigation and Keypad Functions 4

Operation ................................................................................. 9

PowerView Menus (First Time Start Up) 9
Setting Up the Display 12
Main Menu Options 18
Faults and Warnings 20
Utilities Menu 23
Modbus® Setup 25
Selecting Engine ECU 26

Troubleshooting ................................................................... 27

(THIS PAGE INTENTIONALLY LEFT BLANK)

Introduction

Congratulations on purchasing your PowerView display, a
multifunction tool that provides a window into the many
parameters and service codes of modern electronic engines
and transmissions.

This guide is intended to help you set up your PowerView
display and identify navigation basics and product features.
The display’s simple navigation and intuitive yet powerful
features allow you to master the product in no time.

Additional information can be found on our website at
www.fwmurphy.com/powerview.

00-02-0605 - 1 - Rev 09-10-08

•

Engine and Transmission Parameters

The following are some of the engine and transmission
parameters which may be displayed in standard or metric
units as well as in English, Spanish, French, Italian, or
German languages (when applicable, consult engine or
transmission manufacturer for SAE J1939 supported
parameters):

• Engine RPM

• Engine hours

• System voltage

• Percent engine load at the

current RPM

• Coolant temperature

• Oil pressure

• Fuel economy

• Throttle position

• Engine manifold air

temperature

• Current fuel consumption

00-02-0605 - 2 - Rev 09-10-08

Transmission oil

pressure

• Transmission oil
temperature

• Transmission gear
position

• Engine configuration
parameters

• Active fault codes

• Stored fault codes

Faceplate Features

00-02-0605 - 3 - Rev 09-10-08

Navigation and Keypad Functions

The keypad on the PowerView display is a capacitive touch
sensing system. There are no mechanical switches to wear
or stick. When a key is touched, feedback is provided by the
screen flashing. The keys on the keypad perform the
following functions:

Menu – Enter or exit menu screens.

Left Arrow – Scroll the screen or move the

parameter selection to the left or upward.
Right Arrow – Scroll the screen and move

the parameter selection to the right or
downward.

Enter Key – Select a menu or parameter or
hide/view an active fault code.

00-02-0605 - 4 - Rev 09-10-08

Basic Navigation

1. When Menu is pressed, the main menu items are
displayed.

00-02-0605 - 5 - Rev 09-10-08

2. Touching the Arrow Keys will move the selection bar to
other menu items.

00-02-0605 - 6 - Rev 09-10-08

3. Certain menus have multiple pages of items. Scrolling
past the top item or bottom item on the current page will
reveal other menu items on additional pages.

00-02-0605 - 7 - Rev 09-10-08