FCC ID: HSW-SEM2410
Cirronet Inc. will place the following statement in the front of each user/installers
manual:
Important Regulatory Information
Cirronet Product FCCID: HSW-XXXX
Fill in FCC ID number
Note: This unit has been tested and found to comply with the limits for a
class A digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the instruction manual, may
cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in
which case the user will be required to correct the interference at their
expense.
FCC ID: HSW-SEM2410
In order to meet FCC s MPE requirements, Cirronet Corporation will add the following
statements to the each users manual. It may be on the second page.
Notice to users/installers using the 24 dBi parabolic dish antenna in conjunction
with all Cirronet RF products.
FCC rules limit the use of this antenna, when connected to Cirronet RF products for
point-to-point applications only. It is the responsibility of the installer to ensure that
the system is prohibited from being used in point-to-multipoint applications, omnidirectional applications, and applications where there are multiple co-located intentional
radiators transmitting the same information. Any other mode of operation using this
antenna is forbidden.
Information to user/installer regarding FCC s Maximum Permissible Exposure
(MPE) limits.
Notice to users/installers using the following fixed antennas, with Cirronet RF
products:
Andrews 24dBi parabolic dish,
Andrews 18dBi parabolic dish,
Cushcraft 15dBi Yagi,
Mobile Mark 14dBi Corner Reflector,
Mobile Mark 9dBi Corner Reflector
The field strength radiated by any one of these antennas, when connected to Cirronet
RF products, may exceed FCC mandated RF exposure limits. FCC rules require
professional installation of these antennas in such a way that the general public will not
be closer than 2 m from the radiating aperture of any of these antennas. End users of
these systems must also be informed that RF exposure limits may be exceeded if
personnel come closer than 2 m to the apertures of any of these antennas.
Notice to users/installers using the following mobile antennas, with Cirronet RF
products:
Mobile Mark 12dBi omni-directional,
Mobile Mark 9dBi omni-directional,
MaxRad 5dBi whip,
Cirronet Patch antenna,
Ace 2dBi dipole,
Mobile Mark 2dBi Stub
The field strength radiated by any one of these antennas, when connected to Cirronet
RF products, may exceed FCC mandated RF exposure limits. FCC rules require
professional installation of these antennas in such a way that the general public will not
be closer than 20 cm from the radiating aperture of any of these antennas. End users of
these systems must also be informed that RF exposure limits may be exceeded if
personnel come closer than 20 cm to the apertures of any of these antennas.
Loading...