Munchkin STEP, PAIL Owner's Manual
Owner’s Guide
Guía del Usuario
Mode d’emploi
Premium Diaper Pail
Powered by Arm & Hammer™
Cesto de Pañales Premium
Con el Poder de Arm & Hammer™
Seau à Couches de Qualité Supérieure
avec Désodorisant Arm & Hammer™
KEEP FOR FUTURE REFERENCE
GUARDE PARA FUTURA REFERENCIA
À CONSERVER POUR CONSULTATION FUTURE
CCD-0205-000 Rev 1
STEP
TM
PAIL
TM
4 5
How to Install
Important Information
GETTING STARTED
Thank you for choosing Munchkin!
Your premium diaper pail features the odor-ghting power of Arm & Hammer™ baking soda, as well as
self-sealing technology that prevents odors from seeping out.
This pail has been designed to accommodate Arm & Hammer™ Snap, Seal & TossTM bags, as well as
rell rings from Arm & Hammer™, Nursery Fresh®, Up & Up® and Comforts for BabyTM.
Enjoy keeping your nursery smelling fresh! Simply install the lavender scent baking soda PUCK
TM
, as
well as starter ring or Snap, Seal & Toss
TM
bag, to get started.
WARNING: Clean and inspect before use. This is not a toy; for adult use only.
INSTALLING THE PUCK
1 2 3
Mount the Arm & Hammer™
PUCK™ into the bracket on the
underside of the lid.
Turn clockwise to lock into
position.
Turn counter-clockwise to
remove.
Replace the puck every 60 to 90 days for maximum odor protection.
INSTALLING THE REFILL
1 2
1. OPEN THE FRONT DOOR:
Press the button on the silver
inner lid and swing the front
door open from the le side.
2. THEN LIFT THE SILVER INNER
LID: Press the release button
just beneath the inner lid and
li it up.
Release
Button
6 7
How to Install
How to Install / How to Use
FOR SNAP, SEAL & TOSS BAGS
1 2
1. Feed the bottom of the bag
through the sealing flaps and
pull down tightly.
2. Push down to snap the ring
under the locking tabs in all 4
locations.
TO REMOVE THE BAG WHEN FULL: Open the front door and li the
inner lid. Snap the plastic ring closed and push it down through the
sealing flaps. Then remove and replace with a new bag.
USING THE DIAPER PAIL
1 2
1. Open the lid. Roll the used
diaper tightly and push it
through the bag’s seal into
the pail.
2. Close the lid. The opening
will twist automatically to
seal in odors.
FOR DIAPER PAIL REFILL RINGS
1
3
2
4
1. Pull lm out of cartridge, then
down through the center
opening of the rell ring.
2. Tie a knot at the end to create
a bag and feed it through the
sealing flaps.
3. Place the ring inside the
opening with the tabs lined
up with the grooves, so that
the ring locks into place.
4. Pull the bag all the way down
with at least 3 inches resting
on the bottom.
TO REMOVE THE BAG WHEN FULL: Open the front door and slide
the top of the bag through the cutter located beneath the inner lid.
Tie a knot to close the bag and discard.
Pull the remaining material down and tie a knot at the bottom to create
another bag. At least 3 inches should rest on the floor of the pail.
For best results, empty the diaper pail regularly and keep clean.
Loading...