Munchkin Drawer Cabinet Latch Owner's Manual

1.5”

Protect® Drawer & Cabinet Latch Installation Instructions:

Note: Determine where to install your Drawer & Cabinet Latch per the options illustrated on reverse side. IMPORTANT: The latch should have an access gap (opening) of about 1.5” (Fig.1) when the latch is engaged and drawer or door is pulled open. This gap allows you to operate the latch effectively while keeping little ones safe.

Options 1 & 2:

1. Position catch 1” from inside edge of cabinet frame and mark catch position (Fig. 2). Drill holes and secure with enclosed screws. For drawer install, center the catch within drawer.

2. Prior to drilling, position latch so that it engages catch (see note on reverse). Ensure the position allows the latch to pass through the catch when drawer or door is closed. Mark, drill holes and secure with enclosed screws.

Fig. 1

Option 3:

1. Position catch on the underside of cabinet frame about 1” from the center of the cabinet (Fig. 3).

2. Position latch vertically so that the top prong engages directly with the center of the catch (Fig. 4). Prong will snap in place when engaged.

To Clean: Wipe with a clean damp cloth. CAUTION: This product is only a deterrant. Total access is not prevented and should

not be a substitute for adult supervision. Discontinue use when child becomes old enough to defeat it. Discard all packaging components before use.

800.344.BABY (2229) www.munchkin.com

PRODUCT AND DESIGN ARE TM & ©2011 MUNCHKIN, INC. MUNCHKIN, IT’S THE LITTLE THINGS AND PROTECT ARE TRADEMARKS OR REGISTERED TRADEMARKS OF MUNCHKIN, INC. 16689 SCHOENBORN ST., NORTH HILLS, CA 91343. MUNCHKIN BABY CANADA LTD., 50 PRECIDIO CT., UNIT A, BRAMPTON, ON L6S 6E3. MADE IN CHINA/FABRIQUÉ EN CHINE. CCD-0052-000 REV 1

Option 1

Option 2

Fig. 3

NOTE

1”

Make sure finger

grips are facing

notched-out

areas in catch

Fig. 2

Fig. 4

For use in drawers

To release, pinch left

and right prongs

For use in center cabinets with NO vertical walls

Option 3

For use in cabinets with

vertical walls

To release, pinch top

and bottom prongs

To release:

1. Slide prong to side

2. Push down