Multi Voice Radio MVR900 User Manual

MVR900

Multi-Voice Radio LLC.

[phone] • [e-mail]

The Multi-Voice Radio MVR900 System

MVR900 Users Guide

provides advanced full duplex

communication.

Compliance to US/CANADA

This device complies with part 15 of the FCC rules and with RSS 210 of Industry Canada. Operation is subject to the
following two conditions: (1) This device does not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Warning: Changes or modifications made to this equipment not expressly approved by Multi-Voice Radio may void the
user’s authority to operate the equipment.

This Class B digital device complies with Canadian ICES-003.

Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.

FCC ID: ALZMVR900 IC: 10263A-MVR900 Model: MVR900

266E 900S Mapleton, UT 84664

www.multivoiceradio.com

Rev 1.1

5/3/2012

MVR900

Multi-Voice Radio LLC.

[phone] • [e-mail]

Power ON/OFF

Volume UP

Volume DOWN

Mute

Channel / Sync

Measurements

Signal

Battery

Mute LED:

Channel LED:

Product Description

The Multi-Voice Radio combines conference communication with wireless radio. This full duplex system allows hands
free communication on a secure signal for up to 8 people. Additional units may be added as listen only or push to talk

devices.

Specifications

Length: 5.2 in

Height: 3.0 in

Width: 1.0 in

Antenna: 1.3 In

Weight: 10.9 oz

Frequency: 902-928 MHz

Maximum Output Power: 500mW

Range: Up To 3/4 Mile Line of Sight

Frequency Hopping Spread Spectrum

Proprietary Encryption

14 Hour Operation

Rechargeable

Lithium-Ion

6000 mAh

Required Accessory

The MVR900 requires a headset for operation. The headset requirements are: an electret microphone with Impedance
between 1KΩ and 5 KΩ, a speaker with impedance between 8 Ω and 50Ω, a hirose HR30-6P-6S71 connector. To see the
available headsets visit our website at www.multivoiceradio.com

Keypad Description

Hold the button for 3 seconds to turn the device ON.
Hold the button for 3 seconds to turn the device OFF.

Press to toggle the microphone off and on. When the device is in
the optional PPT mode the button becomes the ppt activation.

Press switch between 6 channels. This button also acts as the sync
button during setup.

266E 900S Mapleton, UT 84664

www.multivoiceradio.com

Indicates
the mute is
toggled ON

Indicates what

channel the
user is on.

Rev 1.1

5/3/2012