Multitech MultiVOIP MVP410ST, MultiVOIP MVP810ST Cabling Manual

R

MultiVOIP ISDN BRI

Voice / Fax over IP Networks

MVP410ST
MVP810ST

Cabling Guide

MultiVOIP ISDN/BRI Cabling Guide

Cabling Guide
ISDN/BRI Voice/Fax over IP Networks

Models MVP410ST and MVP810ST
82100250L Rev. A

Copyright

This publication may not be reproduced, in whole or in part, without prior expressed
written permission from Multi-Tech Systems, Inc. All rights reserved.

Copyright © 2007 Multi-Tech Systems, Inc.

Multi-Tech Systems, Inc. makes no representations or warranty with respect to the
contents hereof and specifically disclaims any implied warranty of merchantability or
fitness for any particular purpose. Furthermore, Multi-Tech Systems, Inc. reserves
the right to revise this publication and to make changes from time to time in the
content hereof without obligation of Multi-Tech Systems, Inc. to notify any person or
organization of such revisions or changes. Check Multi-Tech’s web site for current
versions of our product documentation.

Revision Date Description

A 01/12/07 Transition to cabling guide from Quick

Start. (Last QS version was 82100002L.)
Quick setup info transferred to chapter of
companion User Guide (S000385B and
any subsequent).

Trademarks

Multi-Tech and the Multi-Tech logo are registered trademarks of Multi-Tech
Systems, Inc. MultiVOIP is a registered trademark of Multi-Tech Systems, Inc. All
other brand and product names mentioned in this publication are trademarks or
registered trademarks of their respective companies.

Patents

This Product is covered by one or more of the following U.S. Patent Numbers:
6151333, 5757801, 5682386, 5.301.274; 5.309.562; 5.355.365; 5.355.653;

5.452.289; 5.453.986. Other Patents Pending.

GENERAL CONTACT TECHNICAL SUPPORT
Multi-Tech
Systems, Inc.
2205 Woodale Drive
Mounds View,
Minnesota
55112, USA
[phone]
[phone]
Fax: [phone]

www.multitech.com

Country By E-mail By Phone

France support@
India support@

Europe,
Asia,
Africa
U.S.,
Canada,
All Others

multitech.fr

multitechindia.
com
support@
multitech.co.uk

support@
multitech.com

(+33) 1-64
61 09 81
(+91) 124­2340780

(+44) 118
959 7774

(800) 972­2439; (763)
717-5863

2 Multi-Tech Systems, Inc.

MultiVOIP ISDN/BRI Cabling Guide

Introduction

This guide shows you how to make the cable connections to set up your
MultiVOIP

MultiVOIP CD for more information. The “Quick Start Instructions” chapter shows
how to get the MultiVOIP ISDN/BRI unit up and running with a basic configuration.

®

ISDN/BRI unit. See the MultiVOIP User Guide included on the

Safety Warnings

Lithium Battery Caution

A lithium battery on the voice/fax channel board provides backup power for the
timekeeping capability. The battery has an estimated life expectancy of ten
years.

When the battery starts to weaken, the date and time may be incorrect. If the
battery fails, the board must be sent back to Multi-Tech Systems for battery
replacement.

Warning: There is danger of explosion if the battery is incorrectly
replaced.

Ethernet Ports Caution

Caution: The Ethernet ports and command ports are not designed to
be connected to a Public Telecommunictaion network.

Safety Warnings Telecom

Use this product only with UL- and CUL-listed computers (US).

•

• Never install phone wiring during a lightning storm.

• Never install a phone jack in a wet location unless the jack is specifically

designed for wet locations.

• Never touch uninsulated phone wires or terminals unless the phone line has

been disconnected at the network interface.

• Use caution when installing or modifying phone lines.

• Avoid using a phone during an electrical storm; there is a risk of electrical

shock from lightning.

• Do not use a phone in the vicinity of a gas leak.

• To reduce the risk of fire, use only 26 AWG or larger telephone line cord.

• This product must be disconnected from power source and telephone

network interface when servicing.

Safety Recommendations for Rack Instructions

• Ensure proper installation of the MultiVOIP in a closed or multi-unit

enclosure by following the recommended installation as defined by the
enclosure manufacturer. Do not place the MultiVOIP directly on top of other
equipment or place other equipment directly on top of the MultiVOIP.

• If installing the MultiVOIP in a closed or multi-unit enclosure, ensure

adequate airflow within the rack so that the maximum recommended
ambient temperature is not exceeded.

Multi-Tech Systems, Inc. 3