Multiplex FRP, SII-007 Service Manual

SII-007

Wide Lever

5002510

Bottom

Mount Push

for Ice

Narrow Lever

5004851

T op Moun t Push

for Ice

Step 2 Move the lever

down the chute until the arm
buttons line up with the lower
chute holes and insert, making
sure the inner portion of the
plastic lever is located against
the back of the chute opening.

Step 1 As you face the

dispenser hold the top part of
the lever arms and pull both
sides of the “Push For Ice” lever
away from each other until the
tab is removed from the holes
in each side of the chute.

6/09

Parts & Service Communicator

Subject: Push for Ice Lever Conversion

SCOPE

S, SV , SV i, MDH, SCI, FRP (All units with standard rocking chute ice dispensers). This conversion makes on e handed
ice dispense an easy task.

ACTION

Convert your “Push For Ice” chute into a lever by doing the following;

NOTE: Make sure the tab is to the inside of the ice chute so when pressure is applied to the lever it does not swing free. The
pastic levers come in two sizes; 3” narrow and 3.75” wide.

FURTHER ACTIONS

• Contact Foodservice Service Sellersburg Indiana if you have any questions or concerns: 800-367-0427.

Manitowoc Foodservice Sellersburg, 2100 Future Drive, Sellersburg, IN 47172, Tel: [phone], www.manitowocbeverage.com