Multiplex 5428 Installation Manual

EI542800

Instructions

Subject: Model 5428 Support St and

HOW TO ASSEMBLE THE MODEL 5428 SUPPORT STAND

1. Lay the T op Frame Assembly on the floor and attach the Leg Assemblies using 1/4"-20 x 1/2" Hex Head Screws and
Gusset Plates as shown in figure 1.

2. Turn the st and upright and inst all 5/8"-11 x 3" Hex Screws in each corner (refer to figure 2).

3. Place stand in the desired location and level by adjusting the bottom leg levelers.

4. Mount the Model 50 Refrigeration Unit on the st and. Secure with 5/8"-11 x 3" Hex Screws (refer to figure 2).

5. Place the second Model 50 Refrigeration Unit on the service dolly . Secure with 5/8"-11 x 3/4" Hex Screws at each corner
as shown below.

6. Position the second Model 50 Refrigeration Unit under the support stand. Connect the flexible utilities to permit the unit to
be rolled out approximately 2 to 3 ft for service access.

7. Provide suitable means to limit roll-out distance so the flexible utility connections are not overly stressed (chain or wheel
chocks).

8/09

Manitowoc Foodservice Sellersburg, 2100 Future Drive, Sellersburg, IN 47172, Tel: [phone], www.manitowocbeverage.com

Model 5428 Support Stand EI542800

!

Caution

!

Warning

To Avoid Serious Injury Read the following warnings before
beginning an installation. Falure to do so may result in possible
death or serious injury.

DO Adhere to all National and Local Plumbing and Electrical Safety Codes.
DO Turn “Off” incoming electrical service switches when servicing, installing, or repairing equipment.
DO Check that all flare fittings on the carbonation tank(s) are tight. This check should be performed with a

wrench to ensure a quality seal.
DO Inspect pressure on Regulators before starting up equipment.
DO Protect eyes when working around refrigerants.
DO Use caution when handling metal surface edges of all equipment.
DO Handle C0
DO Store C0

2 cylinders and gauges with care. Secure cylinders properly against abrasion.

2 cylinder(s) in well ventilated areas.

DO NOT Throw or drop a C0
DO NOT Connect the C0

possible death or injury . Best to connect th e C0
DO NOT Store C0
DO NOT Release C0

2 cylinders in temperature above 125˚ F (51. 7˚ C) near furnaces, radiator or sources of heat.

2 gas from old cylinder.

DO NOT Touch Refrigeration lines inside units, some may exceed temperatures of 200

2 cylinder. Secure the cylinder(s) in an upright position with a chain.

2 cylinder(s) directly to the product container . Doing so will result in an explosion causing

2 cylinder(s) to a regulator(s).

˚ F (93.3˚ C).

NOTE: Water pipe connections and fixtures directly connected to a potable water supply shall be sized, installed and
maintained in accordance with Federal, State, and Local codes.

DANGER OF ELECTRICAL SHOCK - Disconnect and lock out all
electrical power sources before performing service or maintenance on
this machine -- except when electrical tests are being performed by
qualified service personnel.

Manitowoc Foodservice Sellersburg, 2100 Future Drive, Sellersburg, IN 47172, Tel: [phone], www.manitowocbeverage.com