Multichannel Systems MEA-STIM-ADPT-INV-BC User Manual

MEA-STIM-ADPT-INV-(BC)

Adapter to use MEAs with 16 additional stimulation electrodes (60StimMEA200/30-Ti/ITO
or 60StimMEA 200/10-Ti/ITO) together with MEA1060-INV or MEA1060-INV-BC amplifiers.

G

= Ground
Pin assignment is identical on all four sides.
= Stimulation electrode

S

S

S

G

S

S

Gap for grounding
electrode #15
(only used with BC amplifiers)

Installation:
Remove the upper part of the MEA1060-INV-(BC) amplifier. Put the lid on a dry and clean surface
with an open area in the middle, that the goldspring contacts will not reach the bottom and can
not be damaged. Place the MEA-STIM-ADPT-INV-(BC) adapter on the four screws in each corner of
the amplifiers contact area.
The gap for the grounding cable of electrode #15 (only used with BC amplifiers) should be on the
lower left corner of the amplifier. Fasten the MEA-STIM-ADPT-INV-(BC) adapter with the provided
screw nuts. Replace the upper part of the MEA1060-INV-(BC) amplifier and close the device.

Warning: Please be very careful not to damage the goldspring contacts!

Scope of delivery:
1 MEA-STIM-ADPT-INV-(BC) adapter; 1 wrench (M2); 4 screw nuts (M2).

Multi Channel Systems
MCS GmbH

Aspenhaustrasse 21
72770 Reutlingen
Germany

Fon [phone]­Fax

[phone]

[e-mail]
www.multichannelsystems.com

0

2013 Multi Channel Systems MCS GmbH

Product information is subject to change
without notice.