Multichannel Systems HE-Up User Manual
HE-UP
Heating element for MEA1060-UP Amplifier
Installation
1.) You need the heating element (HE-Up), the connector board (HE-Up-Con)
to the temperature controller TCX, and four provided screws each.
HE-Up
HE-Up-Con
2.) Mount the heating element onto the amplifier’s bottom.
Make sure the input pins go through the hole.
Multi Channel Systems
MCS GmbH
Aspenhaustrasse 21
72770 Reutlingen
Germany
Fon +49-7121-9 09 25Fax
+49-7121-9 09 25-11
info@multichannelsystems.com
www.multichannelsystems.com
0
© 2011 Multi Channel Systems MCS GmbH
Product information is subject to change
without notice.
HE-UP
Input pins
Heating element for MEA1060-UP Amplifier
Installation
3.) Screw the heating element (HE-Up) tightly from the other side
with the provided four bigger screws (M3x6).
Input pins
4) Mount the connector board (HE-Up-Con) so that all six pins are connected to
the heating element. Tighten it with the provided four smaller screws (M2x4).
Scope of delivery:
1 HE-Up + 4 screws (M3x6)
1 HE-Up-Con + 4 screws (M2x4)
Multi Channel Systems
MCS GmbH
Aspenhaustrasse 21
72770 Reutlingen
Germany
Fon +49-7121-9 09 25Fax
+49-7121-9 09 25-11
info@multichannelsystems.com
www.multichannelsystems.com
0
© 2011 Multi Channel Systems MCS GmbH
Product information is subject to change
without notice.
Loading...